The highest voltage for transmitting electrical power in India is

The highest voltage for transmitting electrical power in India is Correct Answer 765 kV

In India, the highest voltage used for transmitting electrical power is 765 kV. This ultra-high voltage is employed to efficiently transmit electricity over extremely long distances while minimizing losses. Higher voltage levels result in lower current flow through the transmission lines, which in turn reduces resistive losses. This is a critical factor in power transmission, allowing for efficient and cost-effective distribution of electricity across the country. Options A, B, C, and D have lower voltage ratings and are generally used for sub-transmission and distribution purposes.
Bissoy MCQ

Related Questions

The highest voltage for transmitting electrical power in India is _______
The Token-Ring architecture was developed for a more efficient way to determine who should be transmitting at any one time. With Ethernet, collisions may take place, causing the transmitting computers to have to retransmit their data. The use of token guarantees that only one computer can transmit at a time. What happens as the network increases in size? Choose the best answer
Principle: A person who voluntarily takes a decision to do something after appreciating the risk involved in such act and then receives an injury, will not be entitled to get any compensation.
Facts: 'X', an electrical engineer, was invited by his friend 'Y', to the factory where he was employed. While they were in the factory, 'Q' a worker in the factory informed 'Y' about some short-circuit in the power room. Hearing this, 'Y' asked 'X' to stay in the office room and rushed to the power room. 'X' however, decided to follow 'Y'. 'X' noticed that if the power supply through a particular electric line could be disconnected, the electrical leakage could be stopped which would prevent further damage. Suddenly 'X' decided to pullout the wire manually even though it was risky. This resulted in a blast in which both 'X' and 'Y' got injured. 'X' had to spend Rs. 1 lakh at the hospital for his treatment. 'X' wants to file a suit for compensation from the management of the factory. Will he succeed?
Some pairs of devices and associated energy changes are given below.
1. Electric generator ⟺ Mechanical to electrical
2. Electric motor ⟺ Electrical to mechanical
3. Diesel engine ⟺ Light to electrical
4. Solar cell ⟺ Chemical to mechanical
Which of the above pair/s is/are correctly matched?
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. The new sending end voltage at the half the voltage regulation is _____________
Which of the following materials is preferred for transmitting electrical energy over long distance ?
What new type of transmitting system, patented by American electrical engineer Edwin H. Armstrong in 1933, eliminated static from radio reception?
Which of the following statements are true about soft power?
1. Soft power can be used by state actors.
2. Soft power can be used by non-state actors.
3. Soft power is the second face of power.
4. Soft power is a form of idealism.
Select the correct answer:
An 3 phase alternator star connected 400 V synchronous motor takes a power input of 5472 watts at rated voltage. Its synchronous reactance is 10** per phase and negligible resistance. If its excitation voltage is adjusted equal to the rated voltage of 400 V, its power factor is _______
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. If the voltage regulation is reduced to 50%, then the power factor at this operation mode will be _________________