Bissoy.com
Doctors Medicines MCQs Q&A

The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be

The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be Correct Answer Greater than 150 V

Related Questions

A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
A 50 Hz synchronous generator is initially connected to a long lossless transmission line which is open circuited at the receiving end. With the field voltage held constant, the generator is disconnected from the transmission line. Which of the following may be said about the steady state terminal voltage and field current of the generator?
Transient stability of the generator is dependent on (a) generator reactance; lower reactance decreases peak power and increases initial rotor angle. (b) how heavily the generator is loaded. (c) generator inertia; higher the inertia, slower the rate of the change of angle. (d) generator output during fault Which of the above is incorrect?
A separately excited DC generator has a no-load voltage of 127 V, Ra = 0.02 Ω and Rsh = 15Ω Find the armature current when the generator terminal voltage is 120 V on load.
In which type of compound generator, the terminal voltage rises with an application of load so that its full load voltage exceeds its no-load voltage?
You install Terminal Services on a Windows 2000 domain controller. You install Terminal Services Client on users' client computers. Users report that when they try to connect to the Terminal server, they receive the following error message: "The local policy of this system does not allow you to logon interactively." When you attempt to log on to the Terminal server as an administrator from a user's computer, you log on successfully. You want users to be able to log on to the Terminal server. What should you do?
In a turbopump system using a gas generator cycle, the flame temperature in the separate gas generator where a small portion of overall propellant is burned is _________ compared to the main gas generator and its mixture ratio is _________ compared to that of the main gas generator.
A shunt generator has an induced voltage on open circuit of 127 V. When the machine is on load the terminal voltage is 120 V. The load current if the field resistance be 15 ohm and armature resistance be 15 ohm.
An electric power generating station supplies power to three loads A, B, and C. Only a single generator is required when anyone load is switched on. When more than one load is on, an auxiliary generator must be started. The Boolean equation for the control of switching of the auxiliary generator will be
Assertion: The process of testing the frequency response of amplifier and filter can be done by sweep frequency generator that automatically varies its frequency over a pre-determined range. Reason: The sweep frequency generator should have a ramp generator which applies a linear ramp voltage the input of a voltage tuned oscillator (VTO).