Related Questions

A policy taken with critical illness rider benefit is being assigned. Which type of assignment would suit the intended purpose because if the life insured is diagnosed with a critical illness, he only should receive the critical illness rider claim?
A Absolute assignment
B Conditional assignment
C Loan assignment
D Collateral assignment
The critical speed of a shaft depends upon its
A Mass
B Stiffness
C Mass and stiffness
D Stiffness and eccentricity
The maximum dry density upto which any soil can be compacted depends upon
A moisture content only
B amount of compaction energy only
C both moisture content and amount of compaction energy
D none of the above
A relationship between processes such that each has some part (critical section) which must not be executed while the critical section of another is being executed, is known as
A semaphore
B mutual exclusion
C multiprogramming
D multitasking
E None of the above
__________ number determines whether the fluid flow in an open channel is supercritical, critical or sub-critical.
A Mach
B Reynolds
C Froude
D Weber
The value of exciting or magnetizing current depends upon which of the following factors ?
A Total m.m.f. required
B The number of turns in the exciting winding
C The way in which the winding is distributed
D All of the above
The relation between tool life (T) and cutting speed (V) is VTn = Constant. In this relation, the value of n depends upon
A Work material
B Tool material
C Working conditions
D Type of chip produced
The value of stress concentration factor depends upon
A Material and geometry of the part
B Geometry of the part
C Material of the part
D None of these
The value of diagram factor depends upon
A Initial conditions of steam
B Back pressure
C Initial pressure of steam
D All of these
The value of fouling factor depends upon the
A Characteristic of process fluid
B Velocity of process fluid containing suspended solids
C Suspended solids in the fluid
D All of the above

Next steps