Related Questions

রেওয়ামিলে দেনাদার ৫২,০০০ টাকা, লিখিত অনাদারি পাওনা ২,০০০ টাকা এবং অলিখিত অন্যদায়ি পাওনা ২,০০০ টাকা। যদি দেনাদারের ওপর ৫% সঞ্চিতি রাখা হয় এবং অনাদায়ি পাওনা সঞ্চিতির ক্রেডিট ব্যালেন্স ১,০০০ টাকা হয়, তাহলে চলতি বছরে অন্যনায়ি পাওনা সঞ্চিতি কত রাখতে হবে? (In trial balance, account receivable is of Tk. 52,000 recorded bad debt of Tk.2,000 and unrecorded bad debt of Tk. 2,000. What is the amount of allowance for doubtful accounts kept in current year if the allowance is 5% on accounts receivable and credit balance in allowance for doubtful accounts currently is of Tk. 1,000 )
A ২,৫০০ টাকা (Tk. 2,500)
B ১,০০০ টাকা (Tk. 1,000)
C ২,৪০০ টাকা (Tk. 2,400)
D 1,500 টাকা (Tk. 1,500)
Draft allowance given to patterns is for
A compensating the liquid state shrinkage
B easy removal of pattern from the mould cavity
C providing support for the core placement
D compensating the solidification shrinkage
The metal patterns as compared to wooden patterns require less
A Shrinkage allowance
B Machining allowance
C Draft allowance
D Distortion allowance
In die casting, machining allowance is
A Small
B Large
C Very large
D Not provided
In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.
A 3-5
B 5-11
C 8-15
D 12-18
Shrinkage allowance on pattern is provided to compensate for shrinkage when
A The temperature of liquid metal drops from pouring to freezing temperature
B The metal changes from liquid to solid state at freezing temperature
C The temperature of solid phase drops from freezing to room temperature
D The temperature of metal drops from pouring to room temperature
Shrinkage allowance on pattern is provided to compensate for shrinkage when the
A Metal changes from liquid state to solid state at freezing temperature
B Solid phase temperature drops from freezing temperature to the room temperature
C Liquid metal temperature drops from pouring temperature to room temperature
D Liquid metal temperature drops from pouring temperature to freezing temperature
The ideal angle of banking provided on the curves on roads depends upon
A Weight of the vehicle
B (Velocity)2 of the vehicle
C Nature of the road surface
D Coefficient of friction between the road and vehicle contact point
An employee is entitled to 20% of his basic pay as dearness Allowance (DA). If his basic pay is Tk. 6300, what is total pay.
A Tk. 1260
B Tk. 4800
C Tk. 7200
D Tk. 7560
If a product requires 10mins for production. where rating of operation is 80% and allowance is 10% then what is the SMV of this product?
A 0.8min
B 8.8min
C 9 min
D 8 min

Next steps