Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
In the consumable electrode shielded metal arc welding process, which of the following observations are correct?
P. The, weld composition does not depend upon the basicity of the slag.
Q. Basic flux is used to achieve low hydrogen content-and low inclusion content in the weld metal.
R. Reverse polarity of the direct current power source is used to weld thin sheets.
S. Coated electrodes are classified by tensile strength of the weld metal deposit.
In backhand welding, the angle between the welding rod and the work is ________ as compared to forehand welding.
In forehand welding, the angle between the welding torch and the work is ________ as compared to backhand welding.
A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
In forehand welding, the angle between the welding rod and the work is kept as
Which of the following characteristics should be possessed by a properly made weld? 1. The weld should not crack in the bend test 2. There should be no scum imbedded In the weld 3. Appearance should be spongy 4. Electrode distance variation should be minimal
Consider the following statements in respect of the oxidizing flame due to excess oxygen in welding: 1) AT high temperature, it combines with many metals to form hard and brittle oxides. 2) It causes the weld bead and the surrounding area to have a scummy appearance 3) It has good welding effect in welding of copper-base metal. Which of the above statements are correct?
The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, $$l$$ = Length of weld and $${\sigma _{\text{t}}}$$ = Allowable tensile stress for weld metal)
Two plates of 12mm and 16mm thickness are to be joined by groove weld. The joint is subjected to factored tensile load of 400kN. Due to some reasons the effective length of weld that could be provided was 150mm only. What is the safety of joint if single-V groove weld is provided?