Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is _________ cutting speed for drilling mild steel with high speed steel drills.
Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
The letters P, Q, R, S, T and U are to be placed one per vertex on a regular convex hexagon, but not necessarily in the same order. Consider the following statements: The line segment joining R and S is longer than the line segment joining P and Q. The line segment joining R and S is perpendicular to the line segment joining P and Q. The line segment joining R and U is parallel to the line segment joining T and Q. Based on the above statements, which one of the following options is CORRECT?
High speed steel drills can be operated at about _________ the speed of high carbon steel drills.
What is the distance covered by boat N upstream in 5 hours? Which of the following option is sufficient alone to find the answer? A) Boat M is travelling downstream with 20% more downstream speed of boat N. Speed of boat M in still water is 10% more than the speed of boat N in still water. B) Boat M and Boat N are travelling downstream with speed 33 km/hr and 40 km/hr respectively and speed of boat M is still water is 2 times the speed of stream. C) Speed of boat M in still water is 6 km/hr less then speed of boat N in still water and speed of stream is 10 km/hr. D) Speed of stream is ½ times the speed of boat N in still water and downstream speed of boat M is 44 km/hr. E) Speed of stream is 10 km/hr and ratio of upstream speed of boat M and boat N is 3 : 2 respectively.
Which two of the following joining processes are autogenous? i. Diffusion welding ii. Electroslag welding iii. Tungsten inert gas welding iv. Friction welding
Which of the following taper is used for ‘shanks of the twist drills’?
Calculate the weld per minute, work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz.
Work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. Calculate R.P.M. and energy requirement of the above circular electrodes assuming effective resistance between electrodes as 100 ohm.
If Rati travels at his usual speed for ‘x’ hours, he covers the same distance as he covered when he travels at a speed 30 km/hr less than usual, but for (x + 3) hours. Which of the following can be determined? (A) If he travels at 20 km/hr less speed than usual, he can cover a distance of 240 km in (x - 1) hours. What is the value of ‘x’? (B) If travels at his usual speed for (t + 2) hours, and at 50% of his usual speed for (t - 2) hours, his average speed for the journey is 68 km/hr. What is his usual speed? (C) His usual speed (in km/hr) is a multiple of 5 between 40 and 50 (both inclusive). If ‘x’ is a whole number, what is his usual speed? (D) If he travels at his usual speed for ‘t’ hours, he covers a distance of 400 km. What is the value of ‘x’?