In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called

In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called Correct Answer Shear zone

The narrow zone surrounding the shear plane in machining is termed as primary shear zone. The area surrounding the chip-tool contact region is called the secondary deformation zone. This zone consists of a part of work material (uncut chip) and a part of chip.
Bissoy MCQ

Related Questions

In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal is called:
Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called
In metal machining, the work-tool contact zone is a zone where heat is generated due to
In metal machining, the zone where the heat is generated due to friction between the moving chip and the tool face, is called
In metal machining, the zone where the heat is generated due to friction between the moving chip and the tool face is called
Inhomogeneous deformation of crystal results in regions of different orientation called deformation bands. Deformation bands have been observed in both fcc and bcc metals, but not in hcp metals.
In plastic deformation of metal, the deformation is temporary and can regain its original shape.
Consider the figures of a metal ball and a metal ring given below.
The metal ball can just pass through the hole of a metal ring formed out of a strip. When the ball is heated it gets stuck. But when the metal is heated
Heat and Thermodynamics mcq question image
According to Irwin’s correction of plasticity at the crack tip, the sufficient crack length is given as the actual crack length plus the radius of the plastic zone. The radius of the plastic zone (rp) in case of plane stress is given as ________
According to Irwin’s correction of plasticity at the crack tip, the effective crack length is given as the actual crack length plus the radius of the plastic zone. The radius of the plastic zone (rp) in case of plane strain is given as ________