Related Questions

In bias ply tyres
A All plies run parallel to one another
B Belts of steel mesh are used in the tyres
C One ply layer runs diagonally one way and another layer runs diagonally the other way
D All of the above
The advantage of a tubeless tyre over tube type tyre is
A Slow air leakage
B Better fuel efficiency
C Less chances of running flat
D All of these
The stability factor of a collector feedback bias circuit is ___________ that of base resistor bias.
A The same as
B More than
C Less than
D None of the above
When I was in town, I tried to" take full advantage" of the many public libraties there. Here ‘take full advantage’ means
A take pictures
B make a survey
C make good use
D visit to get an idea
When I was in town , I tried to take full advantage of the many public libraries there. Here 'take full advantage' means:
A take pictures
B make a survey
C make good use
D visit to get an idea
The temperature at which tyre inflation pressure should be checked is
A 20°C
B 25°C
C 35°C
D Ambient temperature
The aspect ratio (expressed in percentage) of the tyre is defined as the ratio of
A Section width to section height
B Section height to section width
C Wheel diameter to section height
D Wheel diameter to section width
An under-inflated tyre will wear the tread most
A Near the centre
B Near the edges
C In the lateral direction
D In the cross direction
The basic purpose of tyre rotation on automobiles is to
A Avoid ply separation
B Equalize wear
C Get better ride
D None of these
An overinflated tyre will wear the tread most near the
A Edges
B Corners
C Centre
D None of these

Next steps