Related Questions

The safety valve on boiler drum compared to safety valve on superheater is set at
A Same value
B Higher value
C Lower value
D Lower/higher depending on steam flow
The safety valve at superheater as compared to drum safety valve setting is set at
A Higher value
B Lower value
C Same value
D Any value
A safety valve mainly used with locomotive and marine boilers is
A Lever safety valve
B Dead weight safety valve
C High steam and low water safety valve
D Spring loaded safety valve
In order to facilitate starting of locomotive in any position, the cranks of a locomotive with two cylinders, are placed at
A 45° to each other
B 90° to each other
C 120° to each other
D 180° to each other
For the same terminal conditions and valve size, the pressure drop in a fully opened globe valve as compared to that in a gate valve is
A More
B Less
C Equal
D Either A or B; depends on the viscosity of the fluid
A boat has a crack in its bull which is leaking water into the boat and could pump which can pump the water out in 8 hours . If the boat is 168 km away from the shore and the pump is running what is the minimum speed the boat should run at so that it can reach the shore before sinking?
A 5km./hour
B 6 km/hour
C 7 km/hour
D 8km/hour
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
Main gas valve in a gaseous fuel burner is a __________ valve.
A Gate
B Butterfly
C Globe
D None of these
In Meyer's expansion valve, the expansion valve is driven by an eccentric having an angle of advance from
A 50° - 60°
B 60° - 70°
C 70° - 80°
D 80° - 90°
In Meyer's expansion valve, the main valve is driven by an eccentric having an angle of advance from
A 10° - 15°
B 15° - 25°
C 25° - 30°
D 30° - 40°

Next steps