Related Questions

In a/an __________ vessel, the fluid enters and leaves following plug flow.
A Open
B Closed
C Open-closed
D Close-opened
In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant?
A Rotational
B Unsteady
C Turbulent
D Non-uniform
The axial flow compressor is preferred in aircraft gas turbines because of
A Low frontal area
B Higher thrust
C High pressure rise
D None of these
In turbines, the fluid undergoes a continuous steady flow process and the speed of flow is
A Low
B Very low
C High
D Very high
Ms. Rahena needs to get from Town C. The only was to get Town C is taka a bus from Town A to Town B and then take a train from Town B to C. The bus leaves Town A at 8.00 am and reaches Town b after 212 hours. The first train leaves Town B at 9.00 am and then there is a train every 50 minutes. The train reaches Town C 40 minutes after its departure . If Ms. Rehana leaves Town A at 8.00 am, When is the earliest she would arrive at Town C?
A 11:10 am
B 11.20 am
C 12.00 noon
D 10.30 am
Timothy leaves home for school, riding his bicycle at a rate of 9 miles per hour. Fifteen minutes after he leaves, his mother sees a Timothy's math homework lying on his bed and immediately leaves home to bring it to him. If his mother drives at 36 miles per hour, how far (in terms of miles) must she drive before she reaches Tmothy?
A 1/3
B 4
C 3
D 12
In reaction turbines, the axial thrust is due to
A Pressure drop across the rotor
B Change in axial velocity
C Both (A) and (B)
D None of these
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A $$\frac{{{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
B $$\frac{{2{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
C $$\frac{{4{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
D $$\frac{{8{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
A $$\frac{\tau }{2}$$
B $$\tau $$
C $$2\tau $$
D $$4\tau $$
When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a
A D-slide valve
B governor
C Meyer’s expansion valve
D flywheel

Next steps