Related Questions

An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
A $${\frac{1}{4}^{''}} = {1^{'}}{\text{ - }}{0^{''}}$$
B $${\frac{1}{8}^{''}} = {1^{'}}{\text{ - }}{0^{''}}$$
C $${1^{''}} = {100^{'}}$$
D $${\frac{3}{4}^{''}} = {1^{'}}{\text{ - }}{0^{''}}$$
The ________ is a standard element of a section view in a technical drawing.
A Cutting Plane line
B Section lines
C Material hatch pattern
D All of the above
The first step in creating a traditional technical drawing is to ________.
A Draw a series of guide lines
B Set up the meter line
C Align the paper so that it will be positioned square to the parallel bar
D Sharpen the leads in the technical pens
In order to set drawing limits for a 'C' size architectural drawing the drafter should set the limits to ________.
A 0, 0 and 2, 9
B 0, 0 and 17, 11
C 0, 0 and 18, 24
D 0, 0 and 34, 24
Some of the common terms used to describe technical drawing include:
A Drafting
B Engineering Graphics
C Engineering Drawing
D All of the above
If the scale used for drawing a map states that the actual distance of 50 km is represented by 1 cm on the map, then according to this scale what will be the actual distance between los Angeles and Washington D.C if Washington D.C if Washington D.C is 12.22 cm away form America on the map?
A 611 km
B 61 km
C 61.1 km
D 611 cm
If in a synchronous motor, driving a given mechanical load and drawing current at a leading power factor from constant voltage supply its field excitation is increased, its power factor
A will become more
B will become less
C will remain unchanged
D none of the above.
If in a synchronous motor, driving mechanical load and drawing current at lagging power factor from constant voltage supply, its field excitation is increased, then its power factor
A become more
B become less
C remain constant
D none of the above
An Auto-CAD term that refers to a pre-drawn object which is stored in a drawing file and can be inserted into any other drawing file as needed is a __________.
A Block
B Brick
C Balloon
D None of the above
In some circumstances an entire drawing can be inserted into a different drawing as a block. When this is used the base point will default to _________.
A 0, 0
B 10, 10
C 20, 20
D 30, 30

Next steps