Related Questions

In case of pressure vessels having closed ends, the fluid pressure induces
A Longitudinal stress
B Shear stress
C Circumferential stress
D None of these
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If Z is open, which of the following must be true?
A S is open
B T is open
C U is open
D y is open
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If R is closed and U is open, which of the following must be true?
A S is open
B T is open
C T is closed
D Y is closed
The ratio of crippling loads of a column having both the ends fixed to the column having both the ends hinged, is
A 1
B 2
C 3
D 4
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If the maximum number of valves that can be closed at the same time are closed which of the following must true?
A R is open
B S is open
C T is open
D Z is open
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
Pressure difference between two points in vessels, pipelines or in two different pipelines can be measured by a differential manometer. The pressure difference measured as the mm of water coloumn in case of mercury-water, differential manometer is equal to (where, H = difference in height of mercury column in mm).
A H
B 12.6 H
C 13.6 H
D 14.6 H
When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a
A D-slide valve
B governor
C Meyer’s expansion valve
D flywheel
If cohesion between molecules of a fluid is greater than adhesion between fluid and glass, then the free level of fluid in a dipped glass tube will be
A Higher than the surface of liquid
B The same as the surface of liquid
C Lower than the surface of liquid
D Unpredictable
In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant?
A Rotational
B Unsteady
C Turbulent
D Non-uniform

Next steps