Bissoy.com
Doctors Medicines MCQs Q&A

For a Gaussian channel of 1 MHz bandwidth with the signal power to noise spectral density ratio of about 104 Hz, what would be the maximum information rate?

For a Gaussian channel of 1 MHz bandwidth with the signal power to noise spectral density ratio of about 104 Hz, what would be the maximum information rate? Correct Answer 14400 bits/sec

Related Questions

The capacity of a band-limited additive white Gaussian noise (AWGN) channel is given by $$C = W\,{\log _2}\left( {1 + \frac{P}{{{\sigma ^2}W}}} \right)$$     bits per second (bps), where W is the channel bandwidth, P is the average power received and σ2 is the one-sided power spectral density of the AWGN. For a fixed $$\frac{P}{{{\sigma ^2}}} = 1000,$$   the channel capacity (in kbps) with infinite bandwidth (W → ∞) is approximately
The Department of Telecommunications has issued a notice inviting applications for auction of Spectrum in 700 megahertz, 800 MHz, 900 MHz, 1800 MHz, 2100 MHz, 2300 MHz and 2500 MHz bands. The validity of auctioned Spectrum shall be how many years?
A GSM cellular telephone standard requires a minimum of 9 dB rejection of interfering signal levels of -23 dBm at 3 MHz from the carrier, -33 dBm at 1.6 MHz from the carrier, and -43 dBm at 0.6 MHz from the carrier, for a carrier level of -99 dBm. Determine the required local oscillator phase noise at 3 MHz carrier frequency offset.
A signal contains components at 400 Hz and 2400 Hz This signal modulates a carrier of frequency 100 MHz. However, after demodulation, it is found that the 400 Hz signal component is present. The channel bandwidth is 15 kHz. What is the reason for the higher frequency signal not to be detected properly?
কোন এলাকার লিঙ্গ অনুপাত 104 দ্বারা বুঝায়- i. 100 জন মহিলা থাকলে 104 জন পুরুষ আছে ii. প্রতি একশজন নারীর জন্য 104 জন পুরুষ iii. 100 জন পুরুষ থাকলে 104 জন মহিলা আছে নিচের কোনটি সঠিক?
An object X sinks in liquids P and Q but floats in liquid R. Which of the following conclusions can be made from these observations? A) Density of X is more than the density of P B) Density of X is less than the density of R C) Density of P is equal to the density of R D) Density of P is less than the density of R
White noise with power density No/2 = 6 microW/Hz is applied to an ideal filter of gain 1 and bandwidth W rad/s. If the output’s average noise power is 15 watts, the bandwidth W is
Which of the following are the basic differences between vibration signature and noise signature? 1. Vibration signature is essentially in the frequency range zero to 100 cps whereas noise signature is in the range 20 cps to 3000 cps. 2. Vibration signature has well-defined peaks whereas the noise signal is smeared. 3. The intensities of noise signatures arc much less than that of vibration signatures. 4. Detection of vibration signature calls for a microphone whereas that of noise can do with a pickup. Select the correct answer using the code given below.
Let x(t) be a wide sense stationary (WSS) random with power spectral density Sx(f). If Y(t) is the process defined as y(t) = x(2t - 1), the power spectral density SY(f) is
A BPSK scheme operating over an AWGN channel with noise power spectral density of $$\frac{{{N_0}}}{2},$$  uses equiprobable signals
$${s_1}\left( t \right) = \sqrt {\frac{{2E}}{T}} \sin \left( {{\omega _c}t} \right)$$     and $${s_2}\left( t \right) = \sqrt {\frac{{2E}}{T}} \sin \left( {{\omega _c}t} \right)$$
over the symbol internal (0, T). If the local oscillator in a coherent receiver is ahead in phase by 45° with respect to the received signal, the probability of error in the resulting system is