Bissoy.com
Doctors Medicines MCQs Q&A

Let x(t) = 2cos(800πt) + cos(1400πt).x(t) is sampled with the rectangular pulse train shown in the figure. The only spectral components (in kHz) present in the sampled signal in the frequency range 2.5 kHz to 3.5 kHz are
Digital Communication mcq question image

Let x(t) = 2cos(800πt) + cos(1400πt).x(t) is sampled with the rectangular pulse train shown in the figure. The only spectral components (in kHz) present in the sampled signal in the frequency range 2.5 kHz to 3.5 kHz are
Digital Communication mcq question image Correct Answer 2.7, 3.3

Related Questions

A rectangular pulse train s(t) as shown in the figure is convolved with the signal cos2(4π × 103t). The convolved signal will be a
Signal Processing mcq question image
There is only one rail track between stations A and B on a railway line. One hour after the northbound superfast train N leaves station A for station B, the southbound passenger train S reaches station A from station B. The speed of superfast train is twice that of express train E, while the speed of passenger train S is half of that of train E. On some one day train N leaves from station A to station B 20 minutes late than its usual schedule. Both Train N and Train S have increased their speed to maintain the schedule as per the table. If the superfast train doubles its speed, then what should be the ratio (approximately) of the speed of the passenger train to the speed of the superfast train so that the passenger train reaches the station on that day at the exact scheduled time.
A signal containing only two frequency components (3 kHz and 6 kHz) is sampled at the rate of 8 kHz, and then passed through a low pass filter with a cut-off frequency of 8 kHz. The filter output
Consider the signal x(t) shown in the figure. Let h(t) denote the impulse response of the filter matched to x(t), with h(t) being non-zero only in the interval 0 to 4 sec. The slope of h(t) in the interval 3 Digital Communication mcq question image
A source produces binary data at the rate of 10 kbps. The binary symbols are represented as shown in the figure.
Digital Communication mcq question image
The source output is transmitted using two modulation schemes, namely Binary PSK (BPSK) and Quadrature PSK (QPSK). Let and B2 be the bandwidth requirements of BPSK and QPSK respectively. Assuming that the bandwidth of the above rectangular pulses is 10 kHz, B1 and B2 are
In an AM system receiver. the mixer translates the carrier frequency fc to a fixed intermediate frequency of 450 kHz. Given a broadcast signal of frequency 900 kHz. What is the corresponding image frequency when a superhetrodyne receiver is employed with local oscillator frequency greater than the broadcast signal frequency?
Let x(t) and y(t) (with Fourier transforms X(f) and Y(f) respectively) be related as shown in the figure. Then Y(f) is
Signal Processing mcq question image
A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low-pass filter with cutoff frequency 800 Hz. The output signal has the frequency
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
A deterministic signal has the power spectrum given in figure. The minimum sampling rate needed to completely represent signal is
Digital Communication mcq question image