Related Questions

One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
A Improved efficiency
B Better linearity
C High power output per transistor
D The lower modulating power requirement
In a certain growth fund , 3/5 of the investment capital is investment in stocks, and of that portin, 1/3 is invested in preferred stocks. If the mutual fund has $ 8,64,000 invested in preferred stocks , what is the total amount of money invested in the fund?
A $4,230.000
B $3,264,000
C $3,826,000
D $1,974,000
In a certain growth fund, 3/5 of the investment capital is investment in stocks, and of that portion, 13 is invested in preferred stocks. If the mutual fund has $8,46,000 invested in preferred stocks, what is the total amount money invested in the fund?
A 4230000
B 3264000
C 3826000
D 1974000
The Ackerman steering gear mechanism is preferred to the Davis steering gear mechanism, because
A whole of the mechanism in the Ackerman steering gear is on the back of the front wheels and (
B the Ackerman steering gear consists of turning pairs
C the Ackerman steering gear is most economical
D both (a) and (b)
The controlled oscillator synthesizer is sometimes preferred over the direct one because
A It is a simpler piece of equipment
B Its frequency stability is better
C It does not require crystal oscillator
D It is relatively free of spurious frequency
NAND. gates are preferred over others because these
A have lower fabrication area
B can be used to make any gate
C consume least electronic power
D provide maximum density in a chip.
The Ackermann steering mechanism is preferred to the Davis type in automobiles because
A The former is mathematically accurate
B The former is having turning pair
C The former is most economical
D The former is most rigid
Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for _________.
A Circle templates
B Triangles
C Technical pens
D Lettering guides
A turboprop is preferred to turbojet because
A It has high propulsive efficiency at high speeds
B It can fly at supersonic speeds
C It can fly at high elevations
D It has high power for take off
A tri-axial shear test is preferred to direct shear test, because
A It can be performed under all three drainage conditions with complete control
B Precise measurement of pore pressure and change in volume during test, is not possible
C Stress distribution on the failure plane, is non uniform
D None of these

Next steps