Related Questions

Plane P take off at 2:00 am and flies at a constants speed of Xmph. Plane Q takes off at 3:30 am and flies the same forte as plane p but travels at a constant X, how many hours after 3:30 am will plane Q overtake plan P?
A 1.5x/y +0.5
B 2
C 4
D 5
If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be
A 10 mm/m
B 16 mm/m
C 20 mm/m
D 26 mm/m
A body of weight 'W' is required to move up on rough inclined plane whose angle of inclination with the horizontal is 'α'. The effort applied parallel to the plane is given by (where μ = tanφ = Coefficient of friction between the plane and the body.)
A P = W tanα
B P = W tan (α + φ)
C P = W (sinα + μcosα)
D P = W (cosα + μsinα)
The part radiation due to scattered/diffused radiation entering the field of view of a remote sensor other than that from the required target,
A Reduces the contrast of the image and also its sharpness
B Increases the contrast of the image but reduces the sharpness
C Increases both the contrast and sharpness
D Reduces the contrast but increases the sharpness
A 'body' which allows the short wavelength incoming solar radiation to enter in, but does not allow long wave length outgoing infra red radiation to escape out is called the
A Global warming
B Green house
C Atmospheric effect
D Ionosphere
The incoming short-wave solar radiation is balanced by an equal amount of long-wave radiation from earth going back to space. This is known as ________
A Earth radiation
B Wave balance of earth
C Heat balance of earth
D Radiation exchange
The radiation pattern of a parabola antenna is
A Omnidirectional
B A figure of directional
C Highly directional
D None of the above
The radiation pattern of loop antenna is
A Circle
B Semicircle
C Elliptical
D Cardoid or Limacon
Is the geographical representation of a satellite antenna radiation pattern
A Footprint
B Spot
C Earth
D Region
The smallest beam of a satellite antenna radiation pattern
A Zone beam
B Hemispheric beam
C Spot beam
D Global beam

Next steps