Related Questions

Is the geographical representation of a satellite antenna radiation pattern
A Footprint
B Spot
C Earth
D Region
The rectangular beam 'A' has length ‘l’, width ‘b’ and depth ‘d’. Another beam 'B' has the same length and depth but width is double that of 'A'. The elastic strength of beam 'B' will be _________ as compared to beam ‘A’.
A Same
B Double
C Four times
D Six times
A simply supported beam 'A' of length l, breadth b, and depth d carries a central point load W. Another beam 'B' has the same length and depth but its breadth is doubled. The deflection of beam 'B' will be __________ as compared to beam 'A'.
A One-fourth
B One-half
C Double
D Four times
The rectangular beam 'A ' has length l, width b and depth d. Another beam 'B' has the same width and depth but length is double that of 'A'. The elastic strength of beam 'B' will be __________ as compared to beam A.
A Same
B One-half
C One-fourth
D One-eighth
The rectangular beam 'A' has length l, width b and depth d. Another beam 'B' has the same length and width but depth is double that of 'A'. The elastic strength of beam B will be __________ as compared to beam A.
A Same
B Double
C Four times
D Six times
The radiation pattern of a parabola antenna is
A Omnidirectional
B A figure of directional
C Highly directional
D None of the above
The radiation pattern of loop antenna is
A Circle
B Semicircle
C Elliptical
D Cardoid or Limacon
A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is
A 0.207
B 0.307
C 0.407
D 0.508
The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is
A $$\frac{5}{8}$$
B $$\frac{8}{5}$$
C $$\frac{5}{4}$$
D $$\frac{4}{5}$$
If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be
A 10 mm/m
B 16 mm/m
C 20 mm/m
D 26 mm/m

Next steps