Related Questions

To be successful in implementing DSS, organizations should have the following characteristics except:
A a well-controlled data-processing system
B willingness to commit dollars and personnel to the project.
C education and training by the organization
D powerful central computer groups to initiate and manage system projects
E all of the above are important
A combination of a MIS and DSS called _____________ which helps top managers make decisions.
A GIS
B EIS
C EPI
D CAM
'DSs' এর পূর্ণ রূপ কি?
A Data Supply System
B Decision Support System
C Digital Support System
D Data Support System
DSS এর পূর্ণরুপ কি?
A Data supply system
B Decision support system
C Digital support system
D Data support system
A primary use of decision support system (DSS) is to simulate an experiment over by using different parameters and assumptions. What is it called?
A Artificial intelligence
B What if analysis
C Exception report
D Computer assisted experimenting
E None of the above
A company owns some land and buildings for which the following details are relevant : Cost of land Taka 50,000; cost of building Taka 100,000, estimated life of building 20 years, estimated residual value of building Taka 2000; estimated residual value of land Taka 50,000. The company uses the straight line depreciation method. Which is the correct annual depreciation charge for this asset?
A Taka 4000
B Taka 4900
C Taka 7400
D Taka 7500
Which of the following is not the value the key property will hold if the key is a function key?
A F8
B F2
C F9
D Left
A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as
A sunk key
B flat saddle key
C hollow saddle key
D tangent key
When assigning a shortcut key to a symbol, you should always try to select a key or key combination that is:
A Unassigned
B Located on the ten-key pad section of your keyboard.
C Assigned to another task.
D From the same font family as the symbol.
When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
A 0.8 d
B 1.2 d
C 1.57 d
D 1.8 d

Next steps