Related Questions

The ampere-hour efficiency of a leadacid cell is normally between
A 20 to 30%
B 40 to 50%
C 60 to 70%
D 90 to 95%
Which of the following factors adversely affects the capacity of the leadacid battery ?
A Temperature of surroundings
B Specific gravity of electrolyte
C Rate of discharge
D All of the above
As compared to a lead-acid cell, the efficiency of a nickel-iron cell is less due to its
A compactness
B lower e.m.f.
C small quantity of electrolyte used
D higher internal resistance
There is a certain pressure ratio (optimum) for a gas turbine at which its thermal efficiency is maximum. With increase in turbine temperature, the value of pressure ratio for the peak efficiency would
A Remain same
B Decrease
C Increase
D None of the above
When cut-off ratio is __________ the efficiency of Diesel cycle approaches to Otto cycle efficiency.
A Zero
B $$\frac{1}{5}$$
C $$\frac{4}{5}$$
D 1
When cut-off ratio is ________; the efficiency of Diesel cycle approaches to Otto cycle efficiency
A $$\frac{1}{4}$$
B Zero
C $$\frac{1}{5}$$
D 2
Otto cycle efficiency is higher than Diesel cycle efficiency for the same compression ratio and heat input because in Otto cycle
A Heat rejection is lower
B Expansion and compression are isentropic
C Combustion is at constant volume
D Maximum temperature is higher
The ratio of indicated thermal efficiency to the corresponding air standard cycle efficiency is called
A Net efficiency
B Efficiency ratio
C Relative efficiency
D Overall efficiency
The ratio of the indicated thermal efficiency to the air standard efficiency is known as
A Mechanical efficiency
B Overall efficiency
C Volumetric efficiency
D Relative efficiency
In MS Excel, which of the following can be used to copy the value of a cell to another where the value of the source cell was derived through a formula?
A Copy, Value
B Paste, Value
C Copy, Paste Special, Value
D Copy, paste, value

Next steps