Related Questions

The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ = Coefficient of friction, W = Load over the bearing and R = Radius of bearing surface)
A $$\frac{1}{2}$$μWR
B $$\frac{2}{3}$$μWR
C $$\frac{3}{4}$$μWR
D μWR
When the bearing is subjected to large fluctuations of load and heavy impacts, the bearing characteristic number should be _________ the bearing modulus.
A 10 times
B 5 times
C 15 times
D 20 times
If p = bearing pressure on projected bearing area, Z = absolute viscosity of lubricant and N = speed of journal, then the bearing characteristic number is given by
A $$\frac{{{\text{ZN}}}}{{\text{p}}}$$
B $$\frac{{\text{p}}}{{{\text{ZN}}}}$$
C $$\frac{{\text{Z}}}{{{\text{pN}}}}$$
D $$\frac{{\text{N}}}{{{\text{Zp}}}}$$
In the plate loading test for determining the bearing capacity of soil, the size of square bearing plate should be
A less than 300 mm
B between 300 mm and 750 mm
C between 750 mm and 1 m
D greater than 1 m
Terzaghi’s theory of one dimensional consolidation assumes
A Soil is homogeneous and fully saturated
B Water and soil particles are incompressible
C Deformation of the soil, is entirely due to change in volume
D All the above
Ahmad has containers of two different sizes. The total capacity of 16 containers of one size is x gallons,and the total capacity of 8 containers of the other size is also x gallons , and x> 0. In terms of x , what is the capacity, in gallons, of each of the larger containers?
A 4x
B 2x
C x/2
D x/8
The capacity of computer memory is increasing exponentially . At the same time increased capacity is becoming available at cheaper rate. Two years ago 1GB RAM cost TK. 5,000. Now 4GB Ram is available at the same price. If this trend continues what capacity of RAM will you get for TK. 5,000 after 3 years time ?
A 32GB
B 80GB
C 60.72GB
D 76GB
The radius of a friction circle for a shaft rotating inside a bearing is (where r = Radius of shaft and $$\tan \varphi $$  = Coefficient of friction between the shaft and bearing)
A $${\text{r}}\sin \varphi $$
B $${\text{r}}\cos \varphi $$
C $${\text{r}}\tan \varphi $$
D $$\frac{{\text{r}}}{2}\cos \varphi $$
The property of a bearing material which has the ability to accommodate shaft deflections and bearing inaccuracies by plastic deformation without excessive wear and heating, is known as
A Bondability
B Embeddability
C Comformability
D Fatigue strength
In a boundary lubricated bearing, there is a __________ of lubricant between the journal and the bearing.
A Thick film
B Thin film
C Either A or B
D None of these

Next steps