Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following statements regarding static methods are correct?
1. Static methods are difficult to maintain, because you can not change their implementation.
2. Static methods can be called using an object reference to an object of the class in which this method is defined.
3. Static methods are always public, because they are defined at class-level.
4. Static methods do not have direct access to non-static methods which are defined inside the same class.
Consider a process executing on an operating system that uses demand paging. The average time for a memory access in the system is M units if the corresponding memory page is available in memory, and D units if the memory access causes a page fault. It has been experimental measured that the average time taken for a memory access in the process is X units. Which one of the following is the correct expression for the page fault rate experienced by the process?
Assume a memory access to main memory on a cache "miss" takes 30 ns and a memory access to the cache (on a cache "hit") takes 3 ns. If 80% of the processor's memory requests results in a cache "hit", what is the average memory access time?
With regard to computer memory, which of the following statement(s) is/are TRUE?  (A) Cache memory is 'volatile' memory. (B) Magnetic memory is 'volatile' memory.  (C) Flash memory is 'volatile' memory. (D) RAM is 'volatile' memory. Choose the correct answer from the option given below:
What is linear_congruential_engine? for some w using Mersenne Twister algorithm b) Pseudo-random number engine that generates random unsigned integers c) Pseudo-random number engine that generates random unsigned integers in the range for some w using lagged Fibonacci generator d) Pseudo-random number engine that generates random signed integers in the range for some w using Mersenne Twister algorithm
A shared variable x, initialized to zero, is operated on by four concurrent processes W, X, Y, Z as follows. Each of the processes W and X reads x from memory, increments by one, stores it to memory, and then terminates. Each of the processes Y and Z reads x from memory, decrements by two, stores it to memory, and then terminates. Each process before reading x invokes the P operation (i.e., wait) on a counting semaphore S and invokes the V operation (i.e., signal) on the semaphore S after storing x to memory. Semaphore S is initialized to two. What is the maximum possible value of x after all processes complete execution?
In an MS-Excel sheet, cell A1 contains 5, A2 contains 6, and cell A3 contains the formula = A1 + A2. The formula in cell A3 is copied into cell B3 by dragging. Which of the following will be the result (output) displayed in cell B3?
In a paged memory, the page hit ratio is 0.35. The required to access a page in secondary memory is equal to 100 ns. The time required to access a page in primary memory is 10 ns. The average time required to access a page is?
Consider the following statements comparing static RAM with dynamic RAM: In static RAM typical cell requires more number of transistors than the dynamic RAM. Power consumption per bit of static RAM is less than that of dynamic RAM. Dynamic RAM is less expensive than the static RAM. Which of the above statements are correct?
Column A lists the cell parts and Column B lists the functions of the cell part. Column A Column B i. Cell wall A. Control what happens ii. Cell membrane B. Supports the cell. iii. Cytoplasm C. Controls what passes in and out of the cell. iv. Nucleus D. Cell reactions happen in it. Which one of the following options is correct?