Related Questions

I1 is the current flowing in the first mesh. I2 is the current flowing in the second mesh and I3 is the current flowing in the top mesh. If all three currents are flowing in the clockwise direction, find the value of I1, I2 and I3.
Examine the following statements :
i) Factor of safety for steel should be based on its yield stress,
ii) Factor of safety for steel should be based on its ultimate stress,
iii) Factor of safety for concrete should be based on its yield stress,
iv) Factor of safety for concrete should be based on its ultimate stress.
The correct statements are
What are the factors that influence fashion?
1. Economic factor
2. Social factor
3. Political factor
4. Technological factor
Which of the following rivers flowing in Bihar is a north flowing river?
The right limb of a simple U-tube manometer containing mercury is open to the atmosphere while the lift limb is connected to a pipe in which a fluid of specific gravity 0.85 is flowing. The centre of the pipe is 14 cm below the level of mercury in the right limb.Evaluate the pressure of fluid flowing in the pipe if the difference of mercury level in the two limbs is 22 cm.
In a wetted-wall tower, an air-H2S mixture is flowing by a film of water which is flowing as a thin film down a vertical plate. The H2S is being absorbed from the air to the water at a total pressure of 1.50 atm abs and 30oC. The value of kc of 9.567×10-4 m/s has been predicted for the gas-phase mass-transfer coefficient. At a given point the mole fraction of H2S in the liquid at the liquid-gas interface is 2.0×10-5 and pA of H2S in the gas is 0.05 atm. The Henry’s law equilibrium relation is pA(atm) = 609xA (mole fraction in liquid). Calculate the rate of absorption of H2S.
The head lost by water flowing in a channel as a result of turbulence caused by the velocity of the flowing water is called ________
What is the ratio of the mass of refrigerant flowing through condenser and mass of refrigerant flowing through the evaporator, i.e., m2 / m1? If m1 = mass of refrigerant passing through the evaporator m2 = mass of refrigerant passing through the condenser
What is the total mass of refrigerant flowing through the compressor if the masses flowing through each evaporator are m1, m2, and m3?
Waste water flowing with TSS concentration 40 mg/L at the rate of 10 Liter/min is discharged into the river if the river is flowing at the rate of 15 Liter/min, what is the concentration of TSS in the river?