Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

With regard to computer memory, which of the following statement(s) is/are TRUE?  (A) Cache memory is 'volatile' memory. (B) Magnetic memory is 'volatile' memory.  (C) Flash memory is 'volatile' memory. (D) RAM is 'volatile' memory. Choose the correct answer from the option given below:
Which of the following statement about computer memory are true?  A. Secondary storage is non-volatile storage.  B. Video memory found in graphics cards is volatile memory.  C. Primary memory (RAM) is the fastest form of memory in a computer.  Choose the correct answer from the options given below:
A shared variable x, initialized to zero, is operated on by four concurrent processes W, X, Y, Z as follows. Each of the processes W and X reads x from memory, increments by one, stores it to memory, and then terminates. Each of the processes Y and Z reads x from memory, decrements by two, stores it to memory, and then terminates. Each process before reading x invokes the P operation (i.e., wait) on a counting semaphore S and invokes the V operation (i.e., signal) on the semaphore S after storing x to memory. Semaphore S is initialized to two. What is the maximum possible value of x after all processes complete execution?
Consider a process executing on an operating system that uses demand paging. The average time for a memory access in the system is M units if the corresponding memory page is available in memory, and D units if the memory access causes a page fault. It has been experimental measured that the average time taken for a memory access in the process is X units. Which one of the following is the correct expression for the page fault rate experienced by the process?
Assume a memory access to main memory on a cache "miss" takes 30 ns and a memory access to the cache (on a cache "hit") takes 3 ns. If 80% of the processor's memory requests results in a cache "hit", what is the average memory access time?
Which of the following statements are true with regards to the selection of a sample size? (i) The sample size (n) may be a fixed percentage of lot size (N). (ii) The sample size (n) may be kept constant irrespective of lot size (N). (iii) Sample size (n) can be selected at the personal whim of the inspector.
Consider the following two C code segment. Y and X are one- and two-dimensional arrays of size n and n × n respectively, where 2 ≤ n ≤ 10. Assume that in both code segments, elements of y are initialized to 0 and each element X[i] [j] of array X is initialized to i + j. Further assume that when stored in main memory all elements of x are in same main memory page frame. Code segment 1:                 //initialize elements of y to 0                 //initialize elements X[i] [j] of X to i+j                       for (i = 0; i < n; i++)                                 Y[i] += X[0] [i]; Code Segment 2:                 //initialize elements of Y to 0                 //initialize elements X[i] [j] of X to i+j                        for (i = 0; i < n; i++)                                 Y[i] += X[i] [0]; Which of the following statements is/are correct? S1: Final contents of array Y will be same in both code segments S2: Elements of array X accessed inside the for loop shown in code segment 1 are contiguous in main memory S3: Elements of array X accessed inside the for loop shown in code segment 2 are contiguous in main memory
Consider the following statements: 1. Better memory utilization is possible with non-contiguous allocation using fixed size pages 2. Associative memory is used for providing fast access to data stored in cache memory. 3. Direct mapping of cache memory is hard to implement Which of the above statements are correct?
Consider the following statements regarding limits and fits 1. Actual size is the standard size for the part and is the same both for the hole and its shaft. 2: Basic size is the dimension as measured on the manufactured part. 3. Deviation is the algebraic difference between a size and the corresponding basic size. Which of the above statements is/are correct ? 
Consider the following statements the Lesser Himalayas zone
1. It is sandwiched between the Greater Himalayas and the sub-Himalayas
2. The average relief of ridges ranges between 2500-2700 mt.
3. The average relief of valleyes ranges between 500-1200 mt.
Which of the above statement(s) is/are incorrect?