Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

With regard to computer memory, which of the following statement(s) is/are TRUE?  (A) Cache memory is 'volatile' memory. (B) Magnetic memory is 'volatile' memory.  (C) Flash memory is 'volatile' memory. (D) RAM is 'volatile' memory. Choose the correct answer from the option given below:
A shared variable x, initialized to zero, is operated on by four concurrent processes W, X, Y, Z as follows. Each of the processes W and X reads x from memory, increments by one, stores it to memory, and then terminates. Each of the processes Y and Z reads x from memory, decrements by two, stores it to memory, and then terminates. Each process before reading x invokes the P operation (i.e., wait) on a counting semaphore S and invokes the V operation (i.e., signal) on the semaphore S after storing x to memory. Semaphore S is initialized to two. What is the maximum possible value of x after all processes complete execution?
Consider a process executing on an operating system that uses demand paging. The average time for a memory access in the system is M units if the corresponding memory page is available in memory, and D units if the memory access causes a page fault. It has been experimental measured that the average time taken for a memory access in the process is X units. Which one of the following is the correct expression for the page fault rate experienced by the process?
Match the following: (P) static char var; (i) A sequence of memory locations to store addresses (Q) m = malloc(10); m = NULL; (ii) A variable located in the data section of memory (R) char *ptr[10]; (iii) Request to allocate a CPU register to store data (S) register int var1; (iv) A lost memory which cannot be freed
Consider the following two C code segment. Y and X are one- and two-dimensional arrays of size n and n × n respectively, where 2 ≤ n ≤ 10. Assume that in both code segments, elements of y are initialized to 0 and each element X[i] [j] of array X is initialized to i + j. Further assume that when stored in main memory all elements of x are in same main memory page frame. Code segment 1:                 //initialize elements of y to 0                 //initialize elements X[i] [j] of X to i+j                       for (i = 0; i < n; i++)                                 Y[i] += X[0] [i]; Code Segment 2:                 //initialize elements of Y to 0                 //initialize elements X[i] [j] of X to i+j                        for (i = 0; i < n; i++)                                 Y[i] += X[i] [0]; Which of the following statements is/are correct? S1: Final contents of array Y will be same in both code segments S2: Elements of array X accessed inside the for loop shown in code segment 1 are contiguous in main memory S3: Elements of array X accessed inside the for loop shown in code segment 2 are contiguous in main memory
Declaring a variable tell the computer to allocate a memory space that can be accessed by the variable name. The size of the memory space depends on?
In an adjacency list representation of an undirected simple graph G = (V, E), each edge (u, v) has two adjacency list entries: [v] in the adjacency list of u, and [u] in the adjacency list of v. These are called twins of each other. A twin pointer is a pointer from an adjacency list entry to its twin. If |E| = m and |V| = n, and the memory size is not a constraint, what is the time complexity of the most efficient algorithm to set the twin pointer in each entry in each adjacency list?
Which of the following statement about computer memory are true?  A. Secondary storage is non-volatile storage.  B. Video memory found in graphics cards is volatile memory.  C. Primary memory (RAM) is the fastest form of memory in a computer.  Choose the correct answer from the options given below:
Assume a memory access to main memory on a cache "miss" takes 30 ns and a memory access to the cache (on a cache "hit") takes 3 ns. If 80% of the processor's memory requests results in a cache "hit", what is the average memory access time?
Which of the following statements are true with regards to the selection of a sample size? (i) The sample size (n) may be a fixed percentage of lot size (N). (ii) The sample size (n) may be kept constant irrespective of lot size (N). (iii) Sample size (n) can be selected at the personal whim of the inspector.