Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
You want to configure synchronization settings for your office files. Which tool should you use?
Which of the following statement are true from reliability for a research tool? (a) Reliability is fixed for a given testing tool (b) It is correlation of scores on the testing tool itself (c) Reliability can have negative value (d) It varies from sample to sample (e) It is affected by variance of scores Choose the correct option:
Consider the following statements to be true even if they seem to be at variance from commonly known facts and decide which of the conclusions logically follows from the statements. Statements: Some pan are card. No card are tool. Conclusions: I. Some tool are pan. II. All pan are tool. 
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
“Tool bit inserted in the (tool) holder and solid tool” – is included in the classification according to the_____
User level threads are threads that are visible to the programmer and are unknown to the kernel. The operating system kernel supports and manages kernel level threads. Three different types of models relate user and kernel level threads. Which of the following statements is/are true ? (a) (i) The Many - to - one model maps many user threads to one kernel thread (ii) The one - to - one model maps one user thread to one kernel thread (iii) The many - to - many model maps many user threads to smaller or equal kernel threads (b) (i) Many - to - one model maps many kernel threads to one user thread (ii) One - to - one model maps one kernel thread to one user thread (iii) Many - to- many model maps many kernel threads to smaller or equal user threads
Consider the following two-process synchronization solution. Process 0 - - - - - - - - Entry: loop while (turn == 1);  (critical section) Exit: turn = 1; Process 1 - - - - - - - - Entry: loop while (turn == 0);  (critical section) Exit: turn = 0;   The shared variable turn is initialized to zero. Which one of the following is TRUE?
Consider the following solution to the producer-consumer synchronization problem. The shared buffer size is ?. Three semaphores empty, full and mutex are defined with respective initial values of 0, ? and 1. Semaphore empty denotes the number of available slots in the buffer, for the consumer to read from. Semaphore denotes the number of available slots in the buffer, for the producer to write to. The placeholder variables, denoted by P, Q, R, and S, in the code below can be assigned either empty or full. The valid semaphore operations are: wait ( ) and signal ( ). Producer: Consumer: do {         wait (P) ;         wait (mutex) ;         //Add item to buffer         signal (mutex) ;         signal (Q) ; } while (1) ; do {          wait (R) ;          wait (mutex) ;          //Consume item from buffer          signal (mutex) ;          signal (S) ; } while (1) ;   Which one of the following assignments to P, Q, R and S will yield the correct solution?