Bissoy.com
Doctors Medicines MCQs Q&A

Worm gear is used, when two shafts are at _________

Worm gear is used, when two shafts are at _________ Correct Answer Right angles to each other

Worm gear is used when two shafts are at right angles but not intersecting to each other, not to be confused with bevel gear where the axis of two shafts are at right angles and can intersect each other.

Related Questions

Speed reduction in a gear box is achieved using a worm and worm wheel. The worm wheel has 30 teeth and a pitch diameter of 210 mm. If the pressure angle of the worm is 20o, what is the axial pitch of the worm?
Consider two shafts connected with two gears as per the following options: 1. One on each shaft 2. Through an intermediate gear mounted on an intermediate shaft, and every shaft having one gear only 3. Through an intermediate gear mounted on an intermediate shaft, with the intermediate shaft having two gears, whereas the other shafts have one gear each Which of the above represent(s) a simple gear train?
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
Following is the data for transmission system of a Gear box reduction ratios.
1st gear - 4.3 : 1
2nd gear - 3.00 : 1
3rd gear - 2.71 : 1
4th gear - 1 : 1
Final drive reduction is 5.0 : 1
The overall reduction when the vehicle is driven in 2nd gear is
What is worm lead in worm and worm gear?
Hollow shafts can be made as strong as solid shafts by making the twisting moments of both the shafts same. Shafts made by __________ have residual stresses.
A worm gear set is designed to have pressure angle of 300 which is equal to the helix angle. The efficiency of the worm gear set at an interface friction of 0.05 is
Find the speed of the gear if the worm is a three start worm rotating at 500 rpm. The gear has 20 teeth.
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the tangential gear tooth force. Module of the gear is 5mm.