Bissoy.com
Doctors Medicines MCQs Q&A

Air Cooled Heat Exchangers are used in ___________

Air Cooled Heat Exchangers are used in ___________ Correct Answer vehicles

Air Cooled Heat Exchangers are used in vehicles where stable cool water source is not available. Cool air is provided by air flow due to vehicle movement or by fans.

Related Questions

Statement (I): Piston temperature profiles near full load are flattened in case of liquid cooled engines whereas for air cooled engines temperature profiles are steeper. Statement (II): The piston temperature profiles are different in nature for liquid cooled and air cooled engines because of the different values of heat capacities.
Are these statements about the regenerative heat exchangerstrue? Statement 1: Regenerators are commonly used in gas/gas heat recovery applications. Statement 2: Regenerative heat exchangers are also known as capacitive heat exchangers.
Which of the following statements about two-phase heat exchangers are correct? Statement 1: Two-phase heat exchangers undergo phase change during the heat transfer process. Statement 2: It is used mainly in water-to-water heat transfer applications.
Statement 1: Plate heat exchangers are used in heat sensitive foods like milk. Statement 2: Principle behind plate heat exchangers is that there is very less space between the plates and hence quick heating can take place.
The important design and operating considerations for Extended-Surface Compact Heat Exchangers are: (1) Both fluids may have high or low heat transfer coefficients (2) As the tubes are very narrow (low DH), the fluid used should not be corrosive as effective cleaning of tubes is not possible. (3) The fluid pressure drop calculation is important as a regulatory method to ensure long life of the tubes. (4) Unlike shell and tube type heat exchangers, these are limited when it comes to operating pressure and temperature.
The air inside a space capsule is maintained at the required condition by passing it through a set of heat exchanger. The heat exchangers are designed such that the humid air passing through them is cooled and partial condensation of the water vapour occurs. On a psychrometric chart, this process appears as a line which is
Noise produced by cooling fans (employed in air cooled heat exchangers or cooling tower) is mainly caused due to the turbulence created by blade passage through air. It can be reduced by use of a slower fan
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
Indirect contact heat exchangers are preferred over direct contact heat exchangers, because
Multipass Heat Exchangers classify heat exchangers on the basis of construction.