Bissoy.com
Doctors Medicines MCQs Q&A

Shear thinning is also called as __________

Shear thinning is also called as __________ Correct Answer thixotropy

Shear thinning is also called asthixotropy. It is a non-Newtonian fluid, where there is a decrease in viscosity under low shear strain and there is no flow at all until a yield stress is reached after which the flow occurs excluding time-dependent effects. Ketchup is an example of shear thinning.

Related Questions

Statement 1: Considering the equation, μ_a= τ/γ = Kγ(n-1) , for pseudo plastic fluids, n<1 and they’re called Shear thinning liquids and dilatant fluids are called Shear thickening liquids as n>1. Statement 2: Cooked starch solution is a Shear thinning liquid and dairy cream is a Shear thickening liquid.
Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress
The Rheological behaviour of concrete, when represented by shear stress vs rate of shear, is characterized as Where : τ shear stress, Τ0 = (initial) yield value, μ = at-point plastic viscosity, γ̇ = at point rate of shear.
The ultimate shear force at a section of an RCC beam is 300 kN. The shear resisted by concrete is 77.5 kN. What is the shear for which shear reinforcement is required?
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
If number of rivets subjected to single shear per pitch length is 2 and those subjected to double shear per pitch length are 3, then find the shear resistance of rivets is diameter of rivets is 20mm and permissible shear 60N/mm².
If nominal shear stress $${\tau _{\text{v}}}$$ exceeds the design shear strength of concrete $${\tau _{\text{c}}}$$, the nominal shear reinforcement as per IS : 456-1978 shall be provided for carrying a shear stress equal to
Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.
Basic Principles of Biotechnology mcq question image
Which one of the following options is correct?
For laminar flow of a shear thinning liquid in a pipe, if the volumetric flow rate is doubled, the pressure gradient will increase by a factor of
Which of the following is shear thinning fluid?