Bissoy.com
Doctors Medicines MCQs Q&A

Refer to Q7 and Q8 and calculate the mass-transfer coefficient by using the mass and heat transfer analogy.

Refer to Q7 and Q8 and calculate the mass-transfer coefficient by using the mass and heat transfer analogy. Correct Answer 1.665×10-05 mole/m2 .s.Pa

Analogy to heat transfer Sh = 0.453 Re0.568 Sc0.36 = 207.68 So, kG RTd/DAB = 207.68 Therefore, kG = (207.68*DAB) / RTd = 1.665×10-05 mole/m2 .s.Pa.

Related Questions

A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
Experimental results indicate that the local heat transfer coefficient h g for flow over a flat plate with an extremely rough surface is approximated by the relation h x = a x -0.12 Where a is a constant coefficient and x is distance from the leading edge of the plate. What is the relation between this local heat transfer coefficient and the average heat transfer coefficient for a plate of length x?
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
What is the monoisotopic and average mass of valine? Given data: Mass of the most abundant isotope of Carbon (C°)=12.0000, Mass of most abundant isotope of Hydrogen (H°)=1.0078, Mass of most abundant isotope of Oxygen (O°)=15.9949, Mass of most abundant isotope of Nitrogen (N°)=14.0031, The average mass of Carbon (C)=12.011, The average mass of Hydrogen (H)=1.008, The average mass of Oxygen (O)=15.999, The average mass of Nitrogen (N)=14.007.
A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as
A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as
Statement 1: Penetration theory states that mass transfer coefficient is directly proportional to diffusivity coefficient which was later proved wrong. Statement 2: Penetration theory states that mass transfer is based on unsteady mass transfer.
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the number of transfer units of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K
A polished metal pipe 5 cm outside diameter and 370 K temperature at the outer surface is exposed to ambient conditions at 295 K temperature. The emissivity of the surface is 0.2 and the convection coefficient of heat transfer is 11.35 W/m2 degree. Calculate the overall coefficient of heat transfer by the combined mode of convection and radiation
A single pass shell and tube heat exchanger, consisting of a bundle of 100 tubes (inner diameter 25 mm and thickness 2 mm) is used for heating 28 kg/s of water from 25 degree Celsius to 75 degree Celsius with the help of a steam condensing at atmospheric pressure on the shell side with condensing heat transfer coefficient 5000 W/m2 degree. Make calculation for overall heat transfer coefficient based on the inner area. Take fouling factor on the water side to be 0.002 m2 degree/W per tube and neglect effect of fouling factor on the shell side and thermal resistance of the tube wall