Bissoy.com
Doctors Medicines MCQs Q&A

What is meant by take-off safety speed?

What is meant by take-off safety speed? Correct Answer Airspeed at which both the safe climb gradient and directional control is attained

The take-off safety speed is the airspeed at which both the safe climb gradient and directional control is attained. This condition is attained at the time of engine failure in the airborne state.

Related Questions

What is the distance covered by boat N upstream in 5 hours? Which of the following option is sufficient alone to find the answer? A) Boat M is travelling downstream with 20% more downstream speed of boat N. Speed of boat M in still water is 10% more than the speed of boat N in still water. B) Boat M and Boat N are travelling downstream with speed 33 km/hr and 40 km/hr respectively and speed of boat M is still water is 2 times the speed of stream. C) Speed of boat M in still water is 6 km/hr less then speed of boat N in still water and speed of stream is 10 km/hr. D) Speed of stream is ½ times the speed of boat N in still water and downstream speed of boat M is 44 km/hr. E) Speed of stream is 10 km/hr and ratio of upstream speed of boat M and boat N is 3 : 2 respectively.
In the question below, are given a statement followed by three courses of actions numbered I, II and III. On the basis of the information given, you have to assume everything in the statement to be true, and then decide which of the following suggested courses of actions logically follow(s) for pursuing. Statement: Starting October, all new cars will have pedestrian safety features, including new design of the bonnet, to reduce impact on pedestrians during accidents. Advanced safety features are needed in all vehicles in India as vehicle safety cannot be confined to luxury vehicles only. Around 1.5 lakh people are killed in road accidents every year in the country, nearly 60% of them are pedestrians.  Courses of action: I. The government has set a target to reduce the number of road deaths by half in the next two years. The ministry of road transport and highways has been issuing new safety standards for the automobiles along with eliminating the black spots on national highways.  II. By next month, all new cars will have pedestrian safety feature, including new design of the bonnet, to reduce impact on pedestrians during accidents.  III. Ministry of road transport and Highways is planning to implement all safety features in vehicles with active support of vehicle manufacturers. Electronic stability control (ESC) and autonomous emergency braking (AEB) will be incorporated in new vehicles by 2022.
If Rati travels at his usual speed for ‘x’ hours, he covers the same distance as he covered when he travels at a speed 30 km/hr less than usual, but for (x + 3) hours. Which of the following can be determined? (A) If he travels at 20 km/hr less speed than usual, he can cover a distance of 240 km in (x - 1) hours. What is the value of ‘x’? (B) If travels at his usual speed for (t + 2) hours, and at 50% of his usual speed for (t - 2) hours, his average speed for the journey is 68 km/hr. What is his usual speed? (C) His usual speed (in km/hr) is a multiple of 5 between 40 and 50 (both inclusive). If ‘x’ is a whole number, what is his usual speed? (D) If he travels at his usual speed for ‘t’ hours, he covers a distance of 400 km. What is the value of ‘x’?
Rearrange the given sentences in a meaningful order. A) Millions of lives are lost annually throughout the world due to road accidents, resulting in huge loss of finance and resources for individuals as well as for the nation.  B) Road Safety in today’s context is the most significant issue which relates to the safety of public on road. C) There is an urgent need to make people more aware about road safety precautions and why they matter so much.   D) Every year governments throughout the world spend billions on the treatment and welfare of accident victims and their rescue.  E) Strict laws must also be implemented to enforce road safety norms.
Examine the following statements :
i) Factor of safety for steel should be based on its yield stress,
ii) Factor of safety for steel should be based on its ultimate stress,
iii) Factor of safety for concrete should be based on its yield stress,
iv) Factor of safety for concrete should be based on its ultimate stress.
The correct statements are
Study the two cases and answer in terms of relation between the two cases Case 1: The average speed of the bike is \(3\frac{3}{4}\) times the average speed of the bus. A car covers 720 km in 10 hours. How much distance (in km) will a bike cover in 50 minutes if the speed of the bus is half of the speed of the car? Case 2: The average speed of bike is \(1\frac{2}{5}\) times the average speed of the car. A bus covers 441 km in 7 hours. How much distance (in km) will a bike cover in 45 minutes if the speed of the car is twice the speed of the bus?
The speed of six bikes B1, B2, B3, B4, B5 and B6 has been compared. The speed of the B6 exceeds just three bikes. No two bikes have the same speed. The speed of B4 is more than that of B2 but less than that of B6. The speed of B3 is not less than that of B5. The speed B2 is not minimum. If the speed of B5 is not less than that of B2, then which of the following pair of bikes has more speed than that of B4?
The outcome of the spot speed studies carried out at a certain stretch of a highway are as follows. 50th percentile speed = 46 km/h ; 75th percentile speed = 54 km/h ; 85th percentile speed = 60 km/h ; 95th percentile speed = 75 km/h ; 98th percentile speed = 84 km/h ; 100th percentile speed = 95 km/h What is the speed (in km/h units) to be taken to check the geometric design elements.
The question below is followed by three statements I, II, and III. You have to determine whether the data given is sufficient for answering the question. You should use the data and your knowledge of mathematics to choose the best possible answer. A car travels from city P to city Q in T hours with a speed of v km per hour. Distance between cities P and Q is D kilometers. If it increases its speed by 5 kmph it saves some time. Find the actual speed of the car. Statement I: If the car travels from P to Q with its actual speed of v kmph and come back with the speed of v + 5 kmph in 2T – 0.6 hrs Statement II: A bus start form Q at the same time when the car starts from P and the speed of the bus is 50% more than the speed of the car and the bus meets car after covering 60% of the distance Statement III: Distance between PQ is given by D2 – 25D + 200 = 0  
Each of the question below consists of a question and three statements number I, II and III given below it. You have to decide whether the data provided in the statement are sufficient to answer the question. If the bus is travelling from Surat to Ahmadabad and a car is travelling from Ahmadabad to Surat, then what is the distance between Surat and Ahmadabad? I. The speed of a car is 40% less than the speed of bus. Bus started at 9 am and car started at 10 am and they meet at 3 pm of the same day. II. After travelling for 1 hour, because of traffic average speed of bus is decreased by 20% and covers distance between Surat to Ahmadabad in 11 hours. Original speed of car is 20% less than original speed of bus and before crossing bus it covered 200 km if starts 1 hour later than bus. After crossing car, bus covers remaining distance in 5 hours. III. Speed of bus is 10 km/hr more than the speed of car and before crossing car ratio of distances covered bus and car in same time was 5 : 4. Time taken by car to cover the distance between Ahmadabad and Surat is 2 hours 15 minutes more than time taken by bus to cover the same distance.