Bissoy.com
Doctors Medicines MCQs Q&A

An object is subjected to some force. As a result of the force object undergoes in the deformation. If deformation of length is 0.28mm and Actual length is 20 mm then, find simple strain.

An object is subjected to some force. As a result of the force object undergoes in the deformation. If deformation of length is 0.28mm and Actual length is 20 mm then, find simple strain. Correct Answer 0.014

Strain = change in dimension / original dimension = 0.28/20 = 0.014.

Related Questions

Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
A cylinderical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is
A cylindrical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the applied tensile strain then the poisson's ratio of the rod is
The true strain rate is given as ϒ, and conventional strain rate is given as ε. The engineering strain is equal to e. The relationship between conventional strain rate and true strain rate is _______
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
Consider three software items: Program-X, Control Flow Diagram of Program-Y and Control Flow Diagram of Program-Z as shown below Program-X: Control Flow Diagram of Program-Y sumcal (int maxint, int value) {       int result=0, i=0;       if (value <0)       {           Value = -value;       }       while ( (i
A set of actual data are tried with the model : the result obtained is then checked with what happens in reality. If the result from the model does not conform to be actual situation, the model is adjusted to secure a close resemblance to the actual situation. The procedure described above related to
Pavan and Sravan are two persons. If Pavan works with his actual efficiency and Sravan twice of his actual efficiency then it takes 25 days to complete the work. But If Pavan works twice of his actual efficiency and Sravan with his normal efficiency then the work is completed in 20 days. How many days would it take if Sravan alone works with his actual efficiency (in Days)?
The following flow curve shows the deformation behavior of the material in the plastic region. The material is deformed till ε1 and released; the material immediately reached to strain ε2. And the time strain reached to ε3. So, there is a delayed recovery of strain. This is behavior of material is called _________