Bissoy.com
Doctors Medicines MCQs Q&A

R&M are measured in?

R&M are measured in? Correct Answer Maintenance man-hours per flight hour

Reliability and maintainability or R&M are often used together. It is measured in Maintenance man-hours per flight hour (MMH/FH). MMH/FH varies with the type of aircraft. For small aircraft, it is typically less than 1.

Related Questions

A resistance R is measured using the connection shown in the below figure. The current measured is 10 A on ranges 100A and the voltage measured is 125 V on 150 V range. The scales of the ammeter and voltmeter are uniform. The total number of scale divisions of the ammeter is 100 and that of the voltmeter is 150. The scale division can be distinguished. The constructional error of the ammeter is ± 0.3% and that of voltmeter±0.4%. The resistance of the ammeter is 0.25 Ω. The possible error in the measurement of R is?
Two sides of a rectangle were measured. One of the sides (length) was measured 10% more than its actual length and the other side (width) was measured 5% less than its actual length. The percentage error in measure obtained for the area of the rectangle is :
Which of the following instruments indicate the instantaneous value of the electrical quantity being measured at the time at which it is being measured ?
Pressure difference between two points in vessels, pipelines or in two different pipelines can be measured by a differential manometer. The pressure difference measured as the mm of water coloumn in case of mercury-water, differential manometer is equal to (where, H = difference in height of mercury column in mm).
India's latitudinal and longitudinal extent measured in degrees are almost the same, but its north-south extent measured in km is greater than its east-west extent. This is due to the fact that
একজন ছাত্র পরীক্ষাগারে অভিকর্ষজ ত্বরণের মান 9.88 m/sec2 নির্ণয় করন। অপর দিকে যখন সে 0.01 kg ভরের কোনো বাটখারাকে স্প্রিং নিক্তিতে ঝুলিয়ে দিল তখন 0.0980 N বল দেখাচ্ছে। তার পরীক্ষা অভিকর্ষজ ত্বরণের ত্রুটি নির্ণয় কর।(A student measured the value of acceleration due to gravity in the laboratory as 9.88 m/sec2. On the other hand, when he hanged a mass of 0.01 kg in the spring balance, then he found 0.0980 N force. Calculate the percentage of error in the measured value of the acceleration due to gravity.)
Consider the following statements: I. The trigonometric ratio can be measured by measuring the angles in circular system but not in centesimal system and sexagesimal system II. The trigonometric ratio can be measured by measuring the angles in circular system and centesimal system but not in sexagesimal system
In the relation α = βt + λ, α and λ is measured in meter (m) and t is measured in second (s). The SI unit of β must be
Consider the following statements 1. Economic growth is quantitative whereas Economic development is qualitative 2. Growth in the economy is measured by health, education and income measures whereas Development is measured by improvement in GDP. Select the incorrect option
Choose the correct statement. a) The sum of the measured interior angles should be equal (2N - 4) right angles. b) If the exterior angles are measured, their sum should be equal to (2N + 4) right angle. Where N is the number of sides of the traverse.