Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Given below are three quantities named 1, 2 and 3. Based on the given information, you have to determine the relationship between the three quantities. You should use the given data and knowledge of Mathematics to choose between the possible answer. Quantity 1: Area of the innermost square. A square is made by joining the midpoints of a square of area 200 sq. m. The outermost square is called Square 1, The square inside it is called Square 2. The next square is made by joining midpoints of square 2 and is called Square 3. This process goes on. Square 5 is the innermost square. Quantity 2: A man starts with a speed of 10 km/hr. He increases his speed by 10 km/hr every hour at the start and drives at the same speed for that hour. If he traveled a total distance of 550 km. Find the time Quantity 3: Height of cylinder Its volume is equal to the volume of a cone whose radius is 14 cm and height is 39.3 cm. The radius of the cylinder is 14 cm
The CREATE TRIGGER statement is used to create the trigger. THE _____ clause specifies the table name on which the trigger is to be attached. The ______ specifies that this is an AFTER INSERT trigger.
In order to generate a square wave from a sinusoidal input signal, one can use 1. Schmitt trigger circuit 2. Clippers and amplifiers 3. Monostable multivibrator Which of the above statements are correct?
When a sinusoidal voltage wave drives a Schmitt Trigger, the output is a:
Schmitt trigger is a sine wave generator.
Which one of the following statements is/are incorrect regarding waves? (A) wave height is not indicator of wave energy (B) wave height is controlled by wind strength (C) the distance of open water a wave travels over affects the wave height (D) the depth of the sea is important factors affecting wave height Choose the most appropriate answer from the options given below:
The Schmitt trigger circuit is a modification of which of the following multivibrators?
Which of the following statements are correct? (a) CMOS has a higher speed and smaller power than BJT. (b) CMOS ICs inputs should never be left unconnected as it may damage the device. (c) CMOS ICs with Schmitt trigger inputs are useful for better noise immunity. (d) CMOS is most popular logic family in VLSI Technology.
For which of the following functions can a Schmitt trigger be used? 
Schmitt trigger can be used as which one of the following?