Bissoy.com
Doctors Medicines MCQs Q&A

The yield strength of a material is ___________

The yield strength of a material is ___________ Correct Answer the particular stress where a material shows specified elongation under a load

The yield strength of a material is the particular stress where a material shows specified elongation under a load. The elongation of a material is the change in length before being affected by stress to after.

Related Questions

Identify the correct statements from the following:
P. 0.2% yield strength of a material implies 0.2% of the yield strength.
Q. Von-Misses yield criterion implies that yielding occurs when the distortion energy reaches a critical value.
R. Radius of the cylinderical Von-Misses yield surface increases as the grain, size of a single phase material decreases.
S. Tresca's yield criterion gives a circular cylinderical surface in the space of the three principal stresses.
Elastic failure of a material occurs, when the tensile stress equals yield strength, yield point or the elastic limit. Also, the elastic failure occurs according to maximum strain theory, when the maximum tensile strain equals (where, σ = yield strength and E = modulus of elasticity)
Elastic failure of a material occurs, when the tensile stress equals yield strength, yield point or the elastic limit. Also, the elastic failure occurs according to maximum strain theory, when the maximum tensile strain equals (where, $$\sigma $$ = yield strength and E = modulus of elasticity)
When a material is subjected to repeated stress, it fails at stresses below the ultimate strength of the material or even below the Yield strength of material. Such type of failure is known as:
P, Q, R, Sand T are five crops that Babu grows. T is fast growing and more water demanding than R which gives more yield than T. P gives more yield than R and grows faster than Q. Q is more water demanding than T but is second lowest yielder, S is the slowest growing and least water demanding of all crops but gives highest yield. R is more water demanding and grows faster than P. Select the crop or crops that has/ have as many as crops that are more water demanding and as many as crops that give less yield than it. 
If the specimen is deformed plastically beyond the yield stress in one direction, e.g., tension and then after unloading it is loaded in the opposite direction, e.g., compression, it is found that the yield stress is less than the original yield stress. This dependence of yield stress on direction loading is called ____________
The influence of shape of aggregate in strength and workability of concrete are given below in statements S1, S2, S3 and S4. Which of the statements are correct? S1: Rounded aggregate produces concrete with high workability and low strength. S2: Angular aggregate produces concrete with high workability and low strength. S3: Rounded aggregate produces concrete with low workability and high strength. S4: Angular aggregate produces concrete with low workability and high strength.
With regard to the characteristic strength of concrete, consider the following statement: “Test strength of samples means the average strength of X samples. The strength of a sample should not vary by more than ± Y% of the average strength. What will be the values of X and Y here?
According to principal stress theory, which option represents the correct relation between yield strength in shear (YSS) and the yield strength in tension (YST)?
A body starts yielding when it is subjected to stress state with principal stresses of 250 MPa, 50 MPa and - 50 MPa. What is the yield strength of the material. in MPa, if Tresca yield criterion is obeyed?