Bissoy.com
Doctors Medicines MCQs Q&A

The c (fatigue ductility exponent) is a ______________

The c (fatigue ductility exponent) is a ______________ Correct Answer negative fraction

The value of c lies between the -0.5 to -0.7 for most of the metal. This relationship is due to the fact that if the strain amplitude is larger, the failure cycles will be shorter.

Related Questions

The Coffin-Manson relation is described as ________________ where Δεp = the plastic strain amplitude ε’f = fatigue ductility coefficient 2N = number of strain reversal to failure c = fatigue ductility exponent
Consider the following statements regarding ductility of bitumen: 1. Ductility is the property which does not permit bitumen to undergo large deformation without breaking. 2. Bitumen with high ductility are generally adhesive but do not have good cementing properties 3. Ductility must be ascertained at two different temperatures in order to pronounce on the suitability of the material Which of the above statements are correct?
In the flow curve equation given below, if the value of strain hardening exponent is increased, what will be the effect on the ductility of material? σ=Kεn; Where n is strain hardening exponent.
The fatigue ductility exponent x is always positive.
Smaller the value of c (fatigue ductility exponent) ____________ will be the life of component.
Smaller the value of b (fatigue strength exponent) _____________ the fatigue life.
A material is a fatigue tested below the fatigue limit for few millions of cycles and then retested at higher than fatigue limit. This process is known as ___________
If the sample is tested for a large number of cycles below its fatigue limit and the stress is gradually increased above the fatigue limit, the true fatigue limit of material will _______
What are the principles for ensuring the consistency of an equation through dimensional analysis? Statement I: The sum of all exponents of any dimension (e.g., mass), should be the same on both sides of the equation. Statement II: An exponent must itself be a pure / dimensionless number. Statements III: The magnitude of the exponent does not necessarily have to be a whole number.
Which of the following statement is/are correct? a) Penetration test on bitumen is carried out at 27°C. b) Ductility test in bitumen is carried out at 27°C. c) In softening point test on bitumen rate of increase of temperature is 2°C per minute. d) The rate of pulling of standard briquette mould specimen in ductility test is 15 mm per minute.