Bissoy.com
Doctors Medicines MCQs Q&A

The stacking fault in FCC will create a thin region of ___________ in stacking of the FCC.

The stacking fault in FCC will create a thin region of ___________ in stacking of the FCC. Correct Answer HCP

The stacking sequence of the FCC is ABCABCABC. But the introduction of stacking fault in FCC causes shift of plane from ABC|BCABC, here plane A is missing. So the region will become BCBC, this is equivalent to HCP stacking sequence.

Related Questions

The higher the width of the stacking fault _________ will be the stacking-fault energy. Higher the stacking fault energy __________ will be the cross slip.
Stainless steel A has a stacking fault energy of 8 mJ.m-2 and stainless steel B has a stacking fault energy of 45 mJ. m-2. The correct statement out of the following are.
P. A will have a wider stacking faults than B
Q. A will strain harden more rapidly than B
R. A and B will develop similar type of substructure
S. A and B will have the same temperature dependence of flow stress.
The _______ the stacking-fault energy, the higher the separation between the partial dislocations and the ________ the stacking fault.
The material with higher stacking fault energy has higher fatigue strength whereas the material with lower stacking fault will have a lower fatigue limit.
The effect of grain size on the fatigue strength is predominant in material with high stacking fault energy while the effect of grain size is negligible in low stacking fault energy material.
The material with low stacking fault energy is prone to sub-grain formation compared to the metal with high stacking fault energy.
A metal crystallizes into two cubic phases BCC and FCC. The ratio of densities of FCC and BCC is equal to 1.5. Calculate the difference between the unit cell lengths of the FCC and BCC crystals if the edge length of the FCC crystal is equal to 4.0 Å.
In FCC crystals the a/2* unit dislocations can dissociate to produce a ribbon of stacking fault. Which among the following is as an example of the same? ->a/6* + a/6 b) a/2*->a/6* + a/6 c) a/2*->a/6* + a/6 d) a/2*->a/6* + a/6
Which of the following represents the extrinsic stacking fault in the FCC Metal?
The fault not belonging to the classification of fault with the attitude of fault as basis ___________