Which one of the following is best suited for operation of fouling as well as sensitive fluids?

Which one of the following is best suited for operation of fouling as well as sensitive fluids? Correct Answer Forced circulation reboilers

Forced circulation reboilers have blades that keep removing the fouling/scaling getting deposited at the wall surface and hence it is best suited for this operation, it also does not use very high temperatures of operation which works well for sensitive fluids.
Bissoy MCQ

Related Questions

Statement 1: For non-Newtonian fluids, another term called apparent viscosity is used as their viscosity changes with the change in the shear rate. Statement 2: For non-Newtonian fluids, between the transition region, the power number for non-Newtonian fluids is slightly higher than that for Newtonian fluids.
Which one of the following batch-type dryer is the most versatile one, which can handle fouling to sensitive fluids?
Tube wall thickness depends on the cor-rosiveness of the fluids and their operating pressure & temperature and is specified by Birmingham wire gauge (B.W.G)-a number which varies from 8 to 18 with the numbers 14 and 16 being more commonly used. Outside diameter of tubes varies from about 15 to 50 mm; however a tube of less than __________ mm outside diameter is generally not recommended for fouling fluids.
Statement 1: In μ_a= τ/γ = Kγ(n-1) , n = consistency index and K is the flow behaviour index. Statement 2: n= 1 for Newtonian fluids, n<1 for dilatant fluids and n>1 for pseudo plastic fluids.
A single pass shell and tube heat exchanger, consisting of a bundle of 100 tubes (inner diameter 25 mm and thickness 2 mm) is used for heating 28 kg/s of water from 25 degree Celsius to 75 degree Celsius with the help of a steam condensing at atmospheric pressure on the shell side with condensing heat transfer coefficient 5000 W/m2 degree. Make calculation for overall heat transfer coefficient based on the inner area. Take fouling factor on the water side to be 0.002 m2 degree/W per tube and neglect effect of fouling factor on the shell side and thermal resistance of the tube wall
Are these statements about the distillateto concentrate ratio in evaporators true? Statement 1: Lack of wall wetting causes fouling. Statement 2: Fouling depends on the fluid velocity.
Which is the best tube arrangement (in a shell and tube heat exchanger) if the fluids are clean and non-fouling?
The Bernoulli equation is restricted to _____ fluids but the SFEE is valid for _____ fluids as well.
When one of the fluids is highly corrosive and has fouling tendency, it should
Consider we have a Double pipe Heat Exchanger, with inner tube of diameter 20mm (neglect thickness) and outer tube of diameter 30mm. We have two fluids A & B (KA = 15W/mK and KB = 20W/mK) we desire to have their flow rates as 15m3/s and 21m3/s respectively. If their Nusselt number after calculation is Nui = 429 and Nuo = 530. What is the overall heat transfer coefficient of the equipment is no fouling exists?