Bissoy.com
Doctors Medicines MCQs Q&A

With forced convection boiling, nucleate boiling is absent which makes wall temperature very close to interface temperature.

With forced convection boiling, nucleate boiling is absent which makes wall temperature very close to interface temperature. Correct Answer True

In forced convection boiling, heat transfer occurs directly from the wall to the interface and this process becomes so efficient that the wall temperature is unable to sustain the nucleate boiling.

Related Questions

Consider the following statements for Nucleate boiling: 1. For water, the critical heat flux does not exceed 1 MW/m2. 2. Nucleate boiling is the most desirable boiling regime in practice because of high heat transfer rates. 3. Heat flux increases at a higher rate with increase in temperature. Which of the above statements is/are correct?
Consider the following statements regarding nucleate boiling (i) The temperature of the surface is greater than the saturation temperature of the liquid (ii) Bubbles are created by the expansion of entrapped gas oil vapor at small cavities in the surface (iii) The temperature is greater than that in film boiling (iv) The heat transfer from the surface to the liquid is greater than that in the film boiling Which of these statements are correct?
The boiling that takes place in forced convection boiling is popularly known as surface boiling.
I. All the offices on the 9th floor have wall-to-wall carpeting. II. No wall-to-wall carpeting is pink. III.None of the offices on the 9th floor has pink wall-to-wall carpeting. If the first two statements are true, the third statement is
If the first two statements are true, the third statement is :
I. All the offices on the 9th floor have wall-to-wall carpeting.
II. No wall-to-wall carpeting is pink.
III. None of the offices on the 9th floor has pink wall-to-wall carpeting.
Consider the following phenomena (i) Boiling (ii) Free convection in air (iii) Forced convection in air (iv) Conduction in air Identify the correct sequence (heat transfer coefficient)
In transition boiling, heat flux decreases due to which of the following? 1. Low value of film heat transfer coefficient at the surface during 100°C to 120°C surface temperature. 2. Major portion of heater surface is covered by vapour film which has smaller thermal conductivity as compared to liquid. 3. Nucleate boiling occurs very fast. Select the correct answer using the code given below.
Falling film evaporators are those in which evaporation takes place from the film interface with nucleate boiling at the wall.
The presence of forced convection makes the complete mixed fluid boiling pattern known as __________
Which of the following parameters affect burnout heat flux in the nucleate boiling region (i) Heat of evaporation (ii) Temperature difference (iii) Density of vapor (iv) Density of liquid (v) Surface tension at the vapor-liquid interface Mark the correct answer from the codes indicated below