Bissoy.com
Doctors Medicines MCQs Q&A

Fins are not usually attached to the main body of the heat exchanger by ______

Fins are not usually attached to the main body of the heat exchanger by ______ Correct Answer Groove fitting

Fins are attached to the surface by brazing, soldering, welding, gluing and integrally built with the tubes. Fins are not usually attached to the main body of the heat exchanger by Groove fitting.

Related Questions

Which of the following statements about Printed circuit heat exchanger are correct? Statement 1: Printed circuit heat exchanger is an example for direct heat exchanger. Statement 2: It has high heat transfer surface area per unit volume of the exchanger.
Consider the following statements pertaining to heat transfer through fins (i) They must be arranged at right angles to the direction of flow of working fluid (ii) The temperature along the fin is variable and accordingly heat transfer rate varies along the fin elements (iii) Fins are equally effective irrespective whether they are on the hot side or cold side of the fluid (iv) Fins are made of materials that have thermal conductivity higher than that of wall Identify the correct statements
It is said that fins can take a variety of forms (i) Longitudinal fins of rectangular cross section attached to a wall (ii) Cylindrical tubes with radial fins (iii) Conical rod protruding from a wall Identify the correct statement
Forced air flows over a convection heat exchanger in a room heater, resulting in a convective heat transfer coefficient 1.136 k W/m2 K. The surface temperature of heat exchanger may be considered constant at 65 degree Celsius, and the air is at 20 degree Celsius. Determine the heat exchanger surface area required for 8.8 k W of heating
Plate type heat exchangers have less surface area as compared to a similar Shell and Tube heat exchanger. A Shell and Tube Heat Exchanger of equivalent area weigh six-seven times less than a Plate Type heat exchanger.
An electronic semiconductor device generates 0.16 k J/hr of heat. To keep the surface temperature at the upper safe limit of 75 degree Celsius, it is desired that the heat generated should be dissipated to the surrounding environment which is at 30 degree Celsius. The task is accomplished by attaching aluminum fins, 0.5 square mm and 10 mm to the surface. Work out the number of fins if thermal conductivity of fin material is 690W/m K and the heat transfer coefficient is 45k J/square m hr K. Neglect the heat loss from the tip of the fin
Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)
Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow and k = Thermal conductivity of the body)
The equivalent diameter for the annulus of a double pipe heat exchanger, whose inner pipe has fins on the outside is __________ compared to the same size pipes without fins.
A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as