If we desire to use a fluid with high pressure operation, we prefer to keep it in the tube side.

If we desire to use a fluid with high pressure operation, we prefer to keep it in the tube side. Correct Answer True

When we are required to use high pressure flow, we prefer to keep it at the tube side as keeping it at the shell side can damage the tubes, baffles, fins etc.
Bissoy MCQ

Related Questions

Consider we have a Double Pipe Heat Exchanger, with the inner tube of Outer diameter 20mm (thickness 2mm) and outer tube of inner diameter 30mm. We have two fluids A & B, we desire to have their flow rates as 15 Kg/s and 21 Kg/s respectively. Calculate the convective heat transfer coefficient from tube to annulus side. (Given Nusselt number on tube side = 496 and K = 15W/mK)
A single pass shell and tube heat exchanger, consisting of a bundle of 100 tubes (inner diameter 25 mm and thickness 2 mm) is used for heating 28 kg/s of water from 25 degree Celsius to 75 degree Celsius with the help of a steam condensing at atmospheric pressure on the shell side with condensing heat transfer coefficient 5000 W/m2 degree. Make calculation for overall heat transfer coefficient based on the inner area. Take fouling factor on the water side to be 0.002 m2 degree/W per tube and neglect effect of fouling factor on the shell side and thermal resistance of the tube wall
Air flows through a 10 cm internal diameter tube at the rate of 75 kg/hr. Measurements indicate that at a particular point in the tube, the pressure and temperature of air are 1.5 bar and 325 K whilst the tube wall temperature is 375 K. Find heat transfer rate from one meter length in the region of this point The general non-dimensional correlation for turbulent flow in the tube is Nu = 0.023 (Re) 0.8 (Pr) 0.4 Where the fluid properties are evaluated at the bulk temperature
Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation?
1. Fluid flow is frictionless & irrotational
2. Fluid flow is steady
3. Fluid flow is uniform & turbulent
4. Fluid is compressible
5. Fluid is incompressible
A survey of n people in the town A found that 50% of them prefer Brand X. Another survey of 100 people in the town B found that 60% prefer Brand X. In total, 55% of all the people surveyed together prefer Brand X. What is the total number of people surveyed?
A survey of n people in the town of X found that 50% of them prefer Brand A. Another survey of 100 people in the town of Y found that 60% prefer Brand A. In total, 55% of all the people surveyed together prefer Brand A. What is the total number of people surveyed?
Of the 50 researchers in a work group, 40% will be assigned to Team A and the remaining 60% to Team B. However, 70% of the researchers prefer team A and 30% prefer Team B. What is the least possible number of researchers who will not be assigned to the team they prefer ?
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
Consider we have a Double Pipe Heat Exchanger, with the inner tube of Outer diameter 20mm (thickness 2mm) and outer tube of inner diameter 30mm. We have two fluids A & B, we desire to have their flow rates as 15Kg/s and 21Kg/s respectively. What is the value of Hydraulic diameter for the annulus tube?
In a U-tube manometer, one end is open to the atmosphere, the other end attached to a pressurized gas of gauge pressure 40 kPa. The height of the fluid column in the atmospheric side is 60 cm, and that on the gas side is 30 cm. The manometic fluid used is: (Take g = 9.8 m/s2).