Bissoy.com
Doctors Medicines MCQs Q&A

Shell and Tube Heat Exchangers are not commonly used in industries because of their inability to handle high pressure and temperature.

Shell and Tube Heat Exchangers are not commonly used in industries because of their inability to handle high pressure and temperature. Correct Answer False

The above statement is wrong as shell and tube HE is the most common type of HE in industries due to the flexibility it provides to the user in terms of choice of operating pressure and temperature.

Related Questions

The important design and operating considerations for Extended-Surface Compact Heat Exchangers are: (1) Both fluids may have high or low heat transfer coefficients (2) As the tubes are very narrow (low DH), the fluid used should not be corrosive as effective cleaning of tubes is not possible. (3) The fluid pressure drop calculation is important as a regulatory method to ensure long life of the tubes. (4) Unlike shell and tube type heat exchangers, these are limited when it comes to operating pressure and temperature.
A single pass shell and tube heat exchanger, consisting of a bundle of 100 tubes (inner diameter 25 mm and thickness 2 mm) is used for heating 28 kg/s of water from 25 degree Celsius to 75 degree Celsius with the help of a steam condensing at atmospheric pressure on the shell side with condensing heat transfer coefficient 5000 W/m2 degree. Make calculation for overall heat transfer coefficient based on the inner area. Take fouling factor on the water side to be 0.002 m2 degree/W per tube and neglect effect of fouling factor on the shell side and thermal resistance of the tube wall
Plate type heat exchangers have less surface area as compared to a similar Shell and Tube heat exchanger. A Shell and Tube Heat Exchanger of equivalent area weigh six-seven times less than a Plate Type heat exchanger.
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
The handle of a saucepan, 30 cm long and 2 cm in diameter, is subjected to 100 degree Celsius temperature during a certain cooking operation. The average unit surface conductance over the handle surface is 7.35 W/m2 degree in the kitchen air at 24 degree Celsius. The cook is likely to grasp the last 10 cm of the handle and hence the temperature in this region should not exceed 38 degree Celsius. What should be the thermal conductivity of the handle material to accomplish it? The handle may be treated as a fin insulated at the tip
Steam is to be condensed in a shell and tube heat exchanger, 5 m long with a shell diameter of 1 m. Cooling water is to be used for removing the heat. Heat transfer co-efficient for the cooling water, whether on shell side or tube side is the same. The best arrangement is
Are these statements about the regenerative heat exchangerstrue? Statement 1: Regenerators are commonly used in gas/gas heat recovery applications. Statement 2: Regenerative heat exchangers are also known as capacitive heat exchangers.
Air flows through a 10 cm internal diameter tube at the rate of 75 kg/hr. Measurements indicate that at a particular point in the tube, the pressure and temperature of air are 1.5 bar and 325 K whilst the tube wall temperature is 375 K. Find heat transfer rate from one meter length in the region of this point The general non-dimensional correlation for turbulent flow in the tube is Nu = 0.023 (Re) 0.8 (Pr) 0.4 Where the fluid properties are evaluated at the bulk temperature
In most of the shell and tube heat exchangers, the tube pitch is generally __________ the tube diameter.
Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.