Bissoy.com
Doctors Medicines MCQs Q&A

Statement 1: In the transient zone, the power input depends on the density and viscosity of the fluid. Statement 2: In the laminar zone, the power input depends on the density only. It is independent of the viscosity of the fluid.

Statement 1: In the transient zone, the power input depends on the density and viscosity of the fluid. Statement 2: In the laminar zone, the power input depends on the density only. It is independent of the viscosity of the fluid. Correct Answer True, False

In the laminar zone, the power input depends on the viscosity only. It is independent of the density of the fluid.

Related Questions

Which of the following sequence of Heat zones is/are correctly placed? A) Torrid zone, South temperate zone and Frigid zone. B) Torrid zone, North temperate zone and Frigid zone. C) South temperate zone, torrid zone and Frigid zone. Select the correct answer given below.
In the question given below, four sentences are given which may or may not be grammatically correct. From the given options, choose the grammatically correct sentence. A. The members-only zone on the top of the ship has its own luxurious accommodations including suite, private lounges and dining options. B. The members-only zone on the top of the ship has its own luxuries accommodations including suites, private lounges and dining options. C. The members-only zone along the top of the ship has its own luxuries accommodations including suites, private lounges and dining options. D. The members-only zone on the top of the ship has its own luxurious accommodations including suites, private lounges and dining options. 
In a power system, which of the following is/are critical clearance time of a fault related to? 1. Transient reactance 2. Sub-transient reactance 3. Reactive power limit 4. Transient stability limit
Which of the following statements is/are CORRECT regarding the flow of fluid? a) All fluid layers are parallel to each other in case of turbulent flow. b) The Reynold’s number is less than 2000 for turbulent flow and greater than 4000 for laminar flow. c) Two fluid layers don’t cross each other in case of laminar flow
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by (where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3.μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)
An object X sinks in liquids P and Q but floats in liquid R. Which of the following conclusions can be made from these observations? A) Density of X is more than the density of P B) Density of X is less than the density of R C) Density of P is equal to the density of R D) Density of P is less than the density of R
Which of the following statements is/are correct? 1. A system is said to be Finite Impulse Response (FIR), if the output samples of the system depend only on the present input and a finite number of past or previous input samples. 2. If the output of a system y(n) depends only on the present input and past inputs, but not on past outputs, then it is called a non-recursive system. 3. If the output of a system y(n) depends only on the present input and past inputs, but not on past outputs, then it is called a recursive system.
“Power required for turbulent flow is independent of the viscosity of the fluid but proportional to fluid density”, this statement is applicable to which type of regime?
Statement 1: Sieder-Tate and Dittus-boelter equations imply only to laminar flow conditions. Statement 2: Under laminar conditions, the same equation applies both to Newtonian and Non-Newtonian fluids.
Consider the following statements 1. Value of transient stability limit will be lower than steady-state stability limit 2. Transient stability limit is the maximum flow of power through a particular point in the power system without loss of stability when large and sudden disturbances occur 3. Critical clearing angle is related to the steady-state stability limit Which of the above statement(s) is/are correct?