Statement 1: hd/k is _____ Statement 2: _____ is the ratio of convective heat transfer to conductive heat transfer.

Statement 1: hd/k is _____ Statement 2: _____ is the ratio of convective heat transfer to conductive heat transfer. Correct Answer Nussel number, Nussel number

hd/k is Nussel number. Nussel number is the ratio of convective heat transfer to conductive heat transfer.
Bissoy MCQ

Related Questions

For a laminar flow of fluid in a circular tube, 'h₁' is the convective heat transfer co-efficient at velocity 'V₁'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is
For a laminar flow of fluid in a circular tube, 'h1' is the convective heat transfer co-efficient at velocity 'V1'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is
Consider a convective heat flow to water at 75 degree Celsius from a cylindrical nuclear reactor fuel rod of 50 mm diameter. The rate of heat generatioN is 50000000 W/m3 and convective heat transfer coefficient is I kW/m2 K. The outer surface temperature of the fuel element would be
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
Statement 1: Drying is used for preservation of food. Statement 2: Convective drying is indirect drying and conductive drying is direct drying.
Forced air flows over a convection heat exchanger in a room heater, resulting in a convective heat transfer coefficient 1.136 k W/m2 K. The surface temperature of heat exchanger may be considered constant at 65 degree Celsius, and the air is at 20 degree Celsius. Determine the heat exchanger surface area required for 8.8 k W of heating
In a counter flow heat exchanger, water flowing through a tube of 10 cm inner diameter is heated by steam condensing on the outside of the tube. The convective film coefficient on the water and steam side are estimated to be 12000 and 20000 k J/m2 hr degree. Neglecting tube thickness and its resistance to heat flow, workout the overall heat transfer coefficient for the heat exchanger
Which of the following is a wrong statement in the context of a convective heat transfer coefficient in laminar film condensation? The heat transfer coefficient varies as
A rod of 10 mm square section and 160 mm length with thermal conductivity of 50W/m K protrudes from a furnace wall at 200 degree Celsius with convective coefficient 20 W/ square m K. Make calculations for the heat convective up to 80 mm length
Which is true regarding lumped system analysis? (i) Conductive resistance = 0 (ii) Convective resistance = 0 (iii) Thermal conductivity = 0 (iv) Thermal conductivity = infinity Identify the correct statements