Statement 1: Non-Newtonian fluids have a linear relationship between shear stress and shear strain. Statement 2: Tubes are larger than pipes in diameter and have thicker walls.

Statement 1: Non-Newtonian fluids have a linear relationship between shear stress and shear strain. Statement 2: Tubes are larger than pipes in diameter and have thicker walls. Correct Answer False, False

Newtonian fluids have a linear relationship between shear stress and shear strain. Pipes are larger than tubes in diameter and have thicker walls.
Bissoy MCQ

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Statement 1: For non-Newtonian fluids, another term called apparent viscosity is used as their viscosity changes with the change in the shear rate. Statement 2: For non-Newtonian fluids, between the transition region, the power number for non-Newtonian fluids is slightly higher than that for Newtonian fluids.
There are five books of different thickness. A is thicker than C and B is thicker than D. E is not as thick as B, but is thicker than C. D is not as thick as C. Which is the thinnest book?
Statement 1: Considering the equation, μ_a= τ/γ = Kγ(n-1) , for pseudo plastic fluids, n<1 and they’re called Shear thinning liquids and dilatant fluids are called Shear thickening liquids as n>1. Statement 2: Cooked starch solution is a Shear thinning liquid and dairy cream is a Shear thickening liquid.
The true strain rate is given as ϒ, and conventional strain rate is given as ε. The engineering strain is equal to e. The relationship between conventional strain rate and true strain rate is _______
Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.
Basic Principles of Biotechnology mcq question image
Which one of the following options is correct?
What is the relationship between engineering stress and true stress? Given that; s = engineering stress, σ = true stress, e = engineering strain, ε = true strain. d) σ = se+1
Tube wall thickness depends on the cor-rosiveness of the fluids and their operating pressure & temperature and is specified by Birmingham wire gauge (B.W.G)-a number which varies from 8 to 18 with the numbers 14 and 16 being more commonly used. Outside diameter of tubes varies from about 15 to 50 mm; however a tube of less than __________ mm outside diameter is generally not recommended for fouling fluids.
In a shell and tube heat exchanger for a given heat transfer surface area, smaller diameter tubes are favoured as compared to larger diameter ones ; because the smaller diameter tubes