Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements: 1. If x is directly proportional to z and y is directly proportional to z, then (x2 - y2) is directly proportional to z2. 2. If x is inversely proportional to z and y is inversely proportional to z, then (xy) is inversely proportional to z2. Which of the above statements is/are correct?
How is the degree of emulsion polymerization related to the monomer concentration, and the rate of radical generation, Ri? , inversely proportional to Ri b) inversely proportional to Ri, directly proportional to . c) directly proportional to Ri, independent of . d) directly proportional to , independent of Ri
The influence of shape of aggregate in strength and workability of concrete are given below in statements S1, S2, S3 and S4. Which of the statements are correct? S1: Rounded aggregate produces concrete with high workability and low strength. S2: Angular aggregate produces concrete with high workability and low strength. S3: Rounded aggregate produces concrete with low workability and high strength. S4: Angular aggregate produces concrete with low workability and high strength.
With regard to the characteristic strength of concrete, consider the following statement: “Test strength of samples means the average strength of X samples. The strength of a sample should not vary by more than ± Y% of the average strength. What will be the values of X and Y here?
Consider the following statement for a ball falling in a viscous fluid: a) The viscous force is directly proportional to the radius of the ball b) The viscous force is directly proportional to the velocity of the ball c) The viscous force is inversely proportional to the radius of the ball d) The viscous force is inversely proportional to the velocity of the ball Which of the above statements are correct?
When a material is subjected to repeated stress, it fails at stresses below the ultimate strength of the material or even below the Yield strength of material. Such type of failure is known as:
Consider the following: The parallel fillet welded joint is designed for 1) tensile strength 2) compressive strength 3) bending strength 4) shear strength Which of the above is/are correct?
Compared to mild steel, cast iron has (i) High compressive strength (ii) High tensile strength (iii) Low compressive strength (iv) Low tensile strength
Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?
Compared to mild steel, cast iron has
(i) High compressive strength
(ii) High tensile strength
(iii) Low compressive strength
(iv) Low tensile strength