Bissoy.com
Doctors Medicines MCQs Q&A

For repressing, the tool size is _____ as that of compact.

For repressing, the tool size is _____ as that of compact. Correct Answer Same

For repressing, the compact and tool sizes are the same and material flow is in one direction only. With a repressing treatment, pores near the surface are sealed but internal pores remain mostly unaffected. After repressing, there is slight increase in strength with a reduction in ductility and toughness and fatigue strength improves.

Related Questions

Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
Which of the following statements are true with regards to the selection of a sample size? (i) The sample size (n) may be a fixed percentage of lot size (N). (ii) The sample size (n) may be kept constant irrespective of lot size (N). (iii) Sample size (n) can be selected at the personal whim of the inspector.
In the question below, a part of the sentence is underlined. Below are given alternatives to the underlined part which may improve the sentence. Choose the correct alternative. In case no improvement is needed, choose 'No improvement.'   Repressing our memories is a defense mechanism (opt) to save ourselves from all the anxiety and pain. 
External lubrication is not preferred for sizing, coining, and repressing.
Consider the following for local capacity of section: 1. Local section failure is usually encountered in the case of short stocky beam-columns with relatively smaller axial compression ratio and beam-columns bent in reverse curvature. 2. The strength of end section reached under combined axial force and bending, governs the failure. 3. The strength of the section may be governed by plastic buckling of plate elements in the case of plastic, compact and semi-compact sections. Which of the above statements are correct?
Read the given statements and conclusions carefully. Assuming that the information given in the statements is true, even if it appears to be at variance with commonly known facts, decide which of the given conclusions logically follow(s) from the statements. Statement : . All computers are hard-drives. No hard-drive is a compact-disc. Conclusions: I. Some hard-drives are computers. II. No computer is a compact-disc. 
Assertion (A): Light Emitting Diode (LED) lamps offer longer service life as compared to Compact Fluorescent Lamps (CFL).
Reason (R): Light Emitting Diodes (LED) lamps are more energy efficient as compared to the Compact Fluorescent Lamps (CFL).
Select the correct answer:
The price of compact disc players fell over the past decade due to the combination of improving technology and rising incomes. The falling prices of a compact disc caused the
Consider the following statements regarding limits and fits 1. Actual size is the standard size for the part and is the same both for the hole and its shaft. 2: Basic size is the dimension as measured on the manufactured part. 3. Deviation is the algebraic difference between a size and the corresponding basic size. Which of the above statements is/are correct ?