Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following statements is/are correct about a shaper and planer? I) A shaper is intended for small jobs, while a planer is intended for large jobs. II) A shaper has higher machining accuracy compared to a planer. III) A shaper is relatively lighter, smaller and cheaper as compared to a planer.
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
Tool angles are same in shaper as in lathe.
Round nose tool is used in both lathe and shaper.
Gooseneck tool is used in both lathe and shaper.
Shaper is the most important machine tool after lathe and drilling machine.
What will be the renal clearance ratio of a drug whose renal clearance is 40ml/min and the clearance of creatinine is 95ml/min?
In a center lathe, the cutting tool is fed in _________ with reference to the lathe axis.
The cutting tool used in shaper is a _______ point cutting tool.