Bissoy.com
Doctors Medicines MCQs Q&A

Draw type shaper is type of shaper according to______

Draw type shaper is type of shaper according to______ Correct Answer type of cutting stroke

Draw type shaper is type of shaper according to, type of cutting stroke. In this type of shaper, at the time when the ram is moving towards in the direction of column, the metal removal is done.

Related Questions

Push type shaper is type of shaper according to______
horizontal type shaper is type of shaper according to______
Travelling head type shaper is type of shaper according to______
Hydraulic type shaper is type of shaper according to______
Vertical type shaper is type of shaper according to______
Given are the steps to construct an equilateral triangle, with help of a compass, when the length of altitude is given. Arrange the steps. i. Draw a line AB of any length. At any point P on AB, draw a perpendicular PQ equal to altitude length given ii. Draw bisectors of CE and CF to intersect AB at R and T respectively.QRT is required triangle iii. With center Q and any radius, draw an arc intersecting PQ at C iv. With center C and the same radius, draw arcs cutting the 1st arc at E and F
Arrange the steps. These give procedure to draw internal tangent to two given circles of equal radii. i. Draw a line AB which is the required tangent. ii. Draw the given circles with centers O and P. iii. With center R and radius RA, draw an arc to intersect the other circle on the other circle on the other side of OP at B. iv. Bisect OP in R. Draw a semi circle with OR as diameter to cut the circle at A.
Steps given are to draw an involute of a given triangle ABC. Arrange the steps. i. With C as centre and radius C1 draw arc cutting AC-extended at 2. ii. With A as center and radius A2 draw an arc cutting BA- extended at 3 completing involute. iii. B as centre with radius AB draw an arc cutting the BC- extended at 1. iv. Draw the given triangle with corners A, B, C.
Steps are given to draw normal and tangent to an archemedian curve. Arrange the steps, if O is the center of curve and N is point on it. i. Through N, draw a line ST perpendicular to NM. ST is the tangent to the spiral. ii. Draw a line OM equal in length to the constant of the curve and perpendicular to NO. iii. Draw the line NM which is normal to the spiral. iv. Draw a line passing through the N and O which is radius vector.
Which of the following statements is/are correct about a shaper and planer? I) A shaper is intended for small jobs, while a planer is intended for large jobs. II) A shaper has higher machining accuracy compared to a planer. III) A shaper is relatively lighter, smaller and cheaper as compared to a planer.