Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
Floating holder is included in______ method of tool holding devices.
Right hand roughing tool is used in_______.
Microcontrollers are used in automatically controlled products and devices, such as automobile engine control systems, implantable medical devices, remote controls, office machines, appliances, power tools, toys and other embedded systems. By reducing the size and cost compared to a design that uses a separate microprocessor, memory, and input/output devices, microcontrollers make it economical to digitally control even more devices and processes. Mixed signal microcontrollers are common, integrating analog components needed to control non-digital electronic systems. What inference can be drawn from the above?
Which one of the following is true with regard to a CPU having a single interrupt request line and single interrupt grant line? i) Neither vectored nor multiple interrupting devices is possible. ii) Vectored interrupts is not possible but multiple interrupting devices is possible. iii) Vectored interrupts is possible and multiple interrupting devices is not possible. iv) Both vectored and multiple interrupting devices are possible.
“Tool bit inserted in the (tool) holder and solid tool” – is included in the classification according to the_____
Examine the four jumbled sentences. Out of the given options, pick the one that gives their correct order. A. Next, keep tapping the pot on all sides and at the bottom until the plant loosens. B. Finally, slide the plant gently and remove the old potting mix on a newspaper. C. The first thing to do when repotting is to remove the plant from the current pot. D. Begin by holding the plant gently, and turning the pot sideways.
Which of the following are methods of calculating goodwill?
1. Average profit method
2. Super profit method
3. Log method
4. Sum of years digit method
5. Capitalisation of average profit method
6. Capitalisation of super profit method
7. FIFO method
Select the correct answer:
The COP26 was held in_______