Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

“What is the different between height and radius of solid cylinder?” Which of the following option is sufficient alone to find the answer? A) A solid cylinder is made by melting a solid sphere. The radius of cylinder is 3 times the radius of a circle whose area is 154 sq.m. Height of cylinder is equal to the height of cone whose volume is 2772 cubic meters. B) Area of a rectangle whose longer side is ¾ times the radius of a solid cylinder, is 168 sq.m and, Volume of solid cylinder is 2772 cubic meters and its height is 18 m. C) A metallic cone of radius 15m and height 35m is melted into the solid cylinder of radius equal to the radius of a circle whose area is equal to the area of rectangle whose sides are in the ratio 4 : 3 respectively. D) The curved surface area of the solid cylinder is 3 time the surface area of a sphere of radius 7m and height of cylinder is equal to the height of a metallic cone whose curved surface area is 308 sq.m. 
A, B, C, E, F and G are six dancers. B cannot dance better than A. A is a better dancer than G. E is a better dancer than C. E cannot dance better than B or G. F is a better dancer than A. Who among these six is the best dancer?
A displacement sensor (a dial indicator) measures the lateral displacement of a mandrel mounted on the taper hole inside a drill spindle. The mandrel axis is an extension of the drill spindle taper hole axis and the protruding portion of the mandrel surface is perfectly cylindrical measurements are taken with the sensor placed at two positions P and Q as shown in the figure. The readings are recorded as Rx = maximum deflection minus minimum deflection, corresponding to sensor position at X, over one rotation. If RP = RQ > 0, which one of the following would be consistent with the observation?
If joint is to fail by crushing of socket collar then estimate the diameter of socket collar. Given Permissible compressive stress= 126.67 N/mm².; Spigot dia=65mm; thickness 0f collar=15mm
A machine vice whose length of the handle is 150mm and the coefficient of friction for thread and collar are 0.15 and 0.17 respectively has a force applied at handle of 125N. Also the outer and inner diameters of collar are 55mm and 45mm respectively. Find the collar torque in terms of clamping force W assuming uniform wear theory if nominal diameter=22mm and pitch=5mm.
The nut which has a cylindrical grooved collar at its lower end and this collar fits into a corresponding recess in the adjoining piece is named as.
O, P, Q, R, S and T are six sisters who are good at knitting. T is better than S. Q is better than R. O is better than P. Q is not as good as P. S is better than O. Who among the six is the best at knitting?
Consider the following statements regarding limits and fits 1. Actual size is the standard size for the part and is the same both for the hole and its shaft. 2: Basic size is the dimension as measured on the manufactured part. 3. Deviation is the algebraic difference between a size and the corresponding basic size. Which of the above statements is/are correct ? 
In collar mandrel, mandrels are provided with solid collars for turning work pieces having holes of small diameters.
An intelligent boy is doing a jigsaw with 275 pieces. Each day that he fits pieces together there are fewer pieces left, and it is reasonable to assume that he fits more pieces each day because the number left to sort out diminishes progressively. Hence he is able to fit an extra piece as each day goes by. On the first day he fits 20 pieces. How many days does it take for him to complete the puzzle ?